Bosch Washing machine Operating Instructions Manual page 2

Risk of electric shock!
Care Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel Detergent solution pump
- Wipe with a soft, damp cloth. Set programme selector to Off, pull out the mains plug.
- Do not use abrasive detergents.
1. Open and remove service flap.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ... For models with drainage hose:
2. Take drainage hose out of the holder and pull out of the
... if it contains detergent or fabric softener residue.
housing. Remove sealing cap, allow detergent solution
to flow out.
1. Pull out, depress insert, completely remove. Press on sealing cap and insert drainage hose into the
holder.
For models without drainage hose:
2. Open the cover.
2* Carefully unscrew pump cover until the detergent solution begins to run out.
When the service flap is half full,
3. Clean with water and dry. screw back the pump cover and empty the service flap.
Repeat steps until all the detergent solution has run out.
4. Close and lock the cover (place cylinder on guide pin).
3. Carefully unscrew the pump cover (residual water).
5. Insert detergent drawer.
4. Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
5. Reinsert and screw on pump cover.
Leave detergent drawer open so that residual water can evaporate.
6. Insert and close service flap.
Drum
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling Filters in the water supply
No washing in the machine!
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage.
Release water pressure in the supply hose:
Information to indicator lights
1. Turn off the tap!
depending on model
2. Select any programme (except Spin B/Drain b).
3. Press Start M. Leave programme for approx. 40 seconds.
4. Set programme selector to Off.
Clean detergent solution
Close the washing machine 5. Remove hose from tap.
pump (page 9), outlet pipe/drainage
door properly; washing 6. Clean filter with small brush.
may be caught. hose blocked.
7. Depending on the model, remove hose from the rear
of the appliance and clean the filter.
Water in the base pan, appliance lea
Turn on the tap, supply hose kinked/
8. Connect the hose and check for leaks.
king. Call customer service!
jammed;
clean filter (page 9), water pressure too
low.
7 8
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
F Water is running out.
F Water not flowing in.
Detergent not washed in.
F Washing machine door
cannot be opened.
F Programme does not start.
F Detergent solution is not
drained.
F Washing not spun correctly.
F Spin cycle actuated several
times.
F Water not visible in the drum. - Not a fault - water below the visible area.
F Residual water in the
dispenser for care product.
F Odour formation in the
washing machine.
F Foam is coming out of the
detergent drawer.
F Vibrations during spin cycle.
Risk of electric shock! Do not immerse Aqua Stop safety device in water
(contains electric valve).
F Spin result not satisfactory.
F Display panel/indicator lights
do not function while the
appliance is running.
F Programme progress longer
than usual.
F Detergent residue on the
washing.
F If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service (Installation instructions).
9
Safety instructions
- Correctly attach/replace drainage hose.
- Read and follow the operating and installation instructions and all other information enclosed
- Tighten screw fitting on the supply hose. with the washing machine.
- Start M not selected?
- Retain documents for subsequent use.
- Tap not open? Risk of electric shock - Never pull out the mains plug by tugging the power cord!
- Filter blocked? Clean filter (page 9). - Never insert/pull out the mains plug with damp hands.
- Supply hose kinked or jammed? Risk of injury - Washing machine door may become very hot.
- Safety function active. - Caution when draining hot detergent solution.
- Do not climb on the washing machine.
- Rinse Hold selected?
- Start M selected? - Do not lean on the open washing machine door.
Risk of posioning - Keep detergents and care products out of the reach of children.
- Door closed?
Risk of suffocation - Keep packaging, plastic film and packaging parts out of the reach
- Clean detergent solution pump (page 9).
of children.
- Clean outlet pipe and/or drainage hose.
Danger to life On redundant appliances:
- Distribute small and large items of washing in the drum.
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
- Not a fault - unbalanced load detection system adjusts
- Destroy the lock on the washing machine door. This will prevent
imbalance.
children from locking themselves in and suffocating.
Risk of explosion - Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
- Not a fault effect of the care product not impaired. result in an explosion after being loaded into the washing machine.
Beforehand thoroughly rinse items of washing by hand.
- Run Cottons+Linens y 90 ºC programme without
Consumption values
washing. Use standard detergent.
- Too much detergent used?
Mix 1 tablespoon of fabric conditioner with ½ litre of water
and pour into dispenser II in the detergent drawer. Programme Additonal Load
function
- Reduce detergent dosage for the next wash cycle.
Cottons+Linens y 6 kg
- Appliance feet fixed? Wash Plus v
Secure appliance feet (Installation instructions). 40 ºC *
Cottons+Linens y 60 6 kg
- Transportation safety devices removed?
-
ºC
Remove transportation safety devices (Installation
instructions).
Kids Stains 60 ºC* Wash Plus v 6 kg
- Reduced Ironing e selected (page 5)? Cottons+Linens y 90
6 kg
Wash Plus v
ºC*
- Power failure? Synthetics A 40 ºC * Wash Plus v 3 kg
- Fuse tripped? Switch on/replace fuse. ESynthetics A 40 ºC
- If the fault occurs repeatedly, call customer service. (also suitable as Short - 3 kg
programme)
- Not a fault - unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing. zx Mix - 3 kg
Delicates q 30 ºC - 2 kg
- Occasionally phosphate free detergents contain
water insoluble residue.
Woollens u 30 ºC - 2 kg
- Select RinseK or brush the laundry after washing.
* Programme setting with Wash Plus v option and maximum spin speed for testing according to
or in accordance with EN 60 456 and IEC 60 456.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
10 detergent, fluctuations in the mains voltage and selected additional functions.
Washing machine
Current ** Water ** Programme
duration **
Operating instructions
0.60 kWh 53 l 2:13 h
1.20 kWh 55 l 1:30 h
1.02 kWh 45 l 2:15 h
1.90 kWh 60 l 2:13 h
0.55 kWh 50 l 1:24 h
0.54 kWh 40 l 0:55 h
0.59 kWh 35 l 0:50 h
0.22 kWh 32 l 0:32 h
0.14 kWh 30 l 0:40 h
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 11!
11
en