Figure 13-10 Menu 3.5.3.1 Ess X Configuration; Table 13-6 Menu 3.5.3.1 Ess X Configuration - ZyXEL Communications ZyAir Access Point Series User Manual

The following table describes the fields in this menu.
FIELD
ESSID Enter the descriptive name up to 32 alphanumeric characters for identification.
This field is case sensitive.
Active Press [SPACE BAR] to select Yes or No and press [ENTER].
Default Unicast
Key 1 or key 2 is used to encrypt unicast transmissions.
Key
Default Broadcast
Key 3 or key 4 is used to encrypt multicast/broadcast transmissions.
Key
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyAIR and the wireless stations must
use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5 ASCII
characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 ASCII characters
or 26 hexadecimal characters ("0-9", "A-F").
VLAN ID Enter a number from 1 to 255.
LAN Setup
Menu 3.5.3.1 - ESS 1 Configuration
ESSID=
Active= No
Default Unicast Key= 1
Default Broadcast/Multicast Key= 3
Key 1= ********
Key 2= ********
Key 3= ********
Key 4= ********
VLAN ID= 0
Edit MAC Address Filter= No
Press ENTER to Confirm or ESC to Cancel:

Figure 13-10 Menu 3.5.3.1 ESS x Configuration

Table 13-6 Menu 3.5.3.1 ESS x Configuration

Enter "0x" before the key to denote a hexadecimal key. Don't
enter "0x" before the key to denote an ASCII key.
ZyAIR Access Point Series User's Guide
DESCRIPTION
13-11