Getting Started - Sony KV-HF21M50 Service Manual

Using Your New TV

Getting Started

Step 1
Connect the antenna
(For KV-HF21M50)(Malaysia)
If you wish to connect a VCR, see the "Connecting a VCR" diagram below.
Rear of TV
IEC connector
(not supplied)
Antenna cable
(not supplied)
or
Connecting a VCR
To watch the video, press ... (see page 12).
Antenna cable (not supplied)
To antenna
VCR
output
AUDIO VIDEO
VIDEO IN
VIDEO OUT
To video and
audio outputs
Audio/Video cable
(not supplied)
4
Using Your New TV
: Signal flow
Rear of TV
To ˘
(antenna)
R L(MONO)
1
To ... 1
(video input)
: Signal flow
(yellow)
-L (MONO) (white)
-R (red)
Notes
• If you connect a monaural VCR, connect the yellow plug to
yellow jack) and the black plug to
• If you connect a VCR to the ˘ (antenna) terminal, preset the signal
output from the VCR to the program number 0 on the TV.
• When no signal is input to the connected video equipment, the TV screen
becomes blue.
CAUTION
Do not connect the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through the antenna
and other terminals to ground.
Step 2
Insert the batteries
into the remote
Note
• Do not use old batteries nor use different types of batteries together.
Step 3
Preset the channels automatically
Front of TV
1
2
ONE-PUSH AUTOMATIC PROGRAMING
ONE-PUSH AUTOMATIC PROGRAMMING
Tips
• If you want to stop automatic channel presetting, press SELECT twice.
• If your TV has preset an unwanted channel or cannot preset a particular
channel, then preset your TV manually (see page 9).
Note
• During automatic channel presetting, your TV screen will indicate "B/G",
"I", "D/K" or "M" for the TV system.
Now You Are Ready. . .
To watch your TV, see page 11.
(the
-L (MONO) (the white jack).
1 1
VHF LOW B/G
5
Using Your New TV