PBX PX100 User Manual page 34

PX100
Internet Engineering Task Force (IETF). SNMP is used by network management systems to monitor
network-attached devices for conditions that warrant administrative attention. It consists of a set of standards
for network management, including an Application Layer protocol, a dIP-PBXbase schema, and a set of
dIP-PBX objects.
Enable: Enable/Disable the SNMP service, default setting is Disable. (Support SNMP version 1 or SNMP
version 2c).
SNMP Read Community:
information.(default :public)
SNMP Write Community: Specifies the name of the SNMP write community to which the printer device that
this actual destination represents belongs.(Default:private)
SNMP Trap Host: Defines an SNMP trap host to which AppCelera will send trap messages. (Default address is
empty)
SNMP Trap Community: The SNMP trap community name. The community name functions as a password
for sending trap notifications to the target SNMP manager.(Default : public).
User Guide 1.0
SNMP Read Community string so
Page 34 of 50
that EPICenter can retrieve