Wetif DT 392 Operation Manual

DT 392 OPERATION GUIDE
Installation
The Barcode Scanner is preinstalled as an option for DT 392.
Button Management
The default scanner trigger button is at right side. To
assign Scanner Trigger button, follow the procedures
below.
1. Start Button Manager by clicking on
system tray.
2. Select an available unused button marked with the
icon .
to go to the second screen of Button Manager.
3. Click on
4. Click on the
5. Click OK to apply configuration settings and close the window.

Scanner Configuration

To Add/Remove Symbologies, follow the procedures below.
1. Click Start | All Programs | DT Research | Button
Manager | ScannerConfig.
2. Select COM3 and click Connect button.
3. Add Symbology with
Symbology with
4. Select the Beep after scanning barcode checkbox to
enable beep sound after scanning bar code or deselect
it to disable the beep sound.
5. Click OK to apply the configuration settings and close
the window.
Note: Adding only the symbologies you need for testing will give the best results. Adding too many
symbologies all at the same time will influence performance.
Scanner 1/2
Mobiles Tablet
Barcode Scanner
Barcode Scanner
icon to assign the Scanner Trigger to the unused button.
button and Remove
button.
WebDT Mobile Tablet Barcode Scanner Operation Guide
in the
Trigger Button