Summary of Contents for RESEARCH CONCEPTS RC2000
- Page 1 RC2000 Web Server User’s Manual RCI P/N: FP-SER-ETH-SERVR1 v 1.1 Content Subject to Change 13 September 2012 9501 Dice Lane Lenexa, Kansas USA TEL: (913) 422-0210, FAX: (913) 422-0211 Website: WWW.ResearchConcepts.COM Email: support@researchconcepts.com...
-
Page 3: Theory Of Operation
2.0 CONFIGURATION 2.1 Physical Interface The RC2000 Web Server comes in a 4.25” x 3.5” box that mounts using standard rack holes. The box has four indicators to show network and serial port status and activity. The connection from the target PC or other web-enabled device to the web server should be done with a suitable CAT-5e cable. -
Page 4: Detailed Operation
The main page of the user interface contains a remote front panel with a 2x40 character display and a 16-button keypad. This is a Java applet and provides primary interaction with the RC2000 antenna controller. Pressing keys on the panel performs the same action as if keys were actually pressed on... - Page 5 RC2000 Web Server User’s Manual 3.2 Configuration Interface This section describes the various screens available through the web-based configuration interface. The configuration interface can be reached by adding “/config” to the end of the IP address of the unit. For example, with the default IP address the configuration interface can be loaded by entering “192.168.1.1/config”...
- Page 6 RC2000 Web Server User’s Manual Configuration Items > TCP/IP Settings The available TCP/IP settings and default values are shown below Applet Port is the port on which the antenna controller will use to communicate with the Applet. This port must be open and not in use on the target web-enabled device.
- Page 7 RC2000 Web Server User’s Manual Configuration Items > Antenna Controller Settings The available Antenna Controller Settings and default values are shown below. Display Refresh Time is the number of milliseconds between display updates. Key Repeat Time is the number of milliseconds between successive jog keystrokes. Both of these items may be changed to overcome network latency issues.
- Page 8 RC2000 Web Server User’s Manual Firmware Update > User Interface Firmware The User Interface Firmware panel is shown below. Choose a file and click the Start Update button to start the user interface firmware update process. The following panel displays the current progress of the firmware update. Click the Done button to...
- Page 9 By default, this port number is 6767. The packet data of an incoming datagram is relayed directly to the RC2000 internal serial port. The RC2000 response is returned to the host in a similar fashion. The packet structure of a UDP datagram is beyond the scope of this document. For the following...
-
Page 10: Troubleshooting
RC2000 Web Server User’s Manual 4.0 TROUBLESHOOTING 4.1 Web Browser Will Not Load Main Web Page Problem Solution(s) 1. PC or device assigned invalid address. Web browser will not load main web page 2. Ethernet cable not connected or bad.