Subscribe to Our Youtube Channel
Summary of Contents for ACG SEVCON
- Page 1 SEVCON Display Manual Page 1 Copyright © 2009-2013 American Custom Golf Cars, Inc.
-
Page 2: Sevcon Lcd Display
SEVCON LCD Display SEVCON LCD display has following functions: Battery State of Charge (SoC) shown on bar graph at right of the screen and as percent % at top of the bar graph (shown above as 78%) see IMPORTANT INFORMATION on next page. - Page 3 MUST be driven so that a discharge level of 69% or less is achieved, and the Traction Battery MUST BE FULLY CHARGED thereafter, in order for the State of Charge bar graph indicator in the SEVCON Display to self reset to 100% indication.
-
Page 4: Main Screen
Display Screen – Other Functions Main Screen Main screen will display Direction, Speed and Battery Charge Level, it also displays Trip and Odometer (total miles) mileage traveled. If the low water battery symbol appears please check the water level in all batteries. To clear the low water battery symbol push upper arrow button 2 times;... - Page 5 Screen VEHICLE STATUS MONITOR Section A Battery shows Battery Nominal Voltage Trac Drive Status shows current status Section B Cont. Temp. (Controller Temperature) 2. Motor Volts 3. Motor Amps 4. Motor RPM (Rotations Per Minute) 5. Motor Torque in Percent (%) These values will change as soon as you start driving the vehicle.
- Page 6 Screen VEHICLE INPUTS MONITOR on this screen all switch and input signal conditions are displayed: Forward Reverse Seat Drv Select 1 Drv Select 2 Hand Brake Foot Brake Inch FWD sw Inch REV sw Note: Drive profile #2 (Drv Select 2) is only used for testing Purpose to see the Range of motor on the controller. Features not used: Seat Hand Brake...
- Page 7 Screen TIME TO DISTANCE This screen displays the acceleration of the vehicle from 0-1000 feet and will automatically record the performance of the vehicle. It also displays the number of hours the vehicle was driven. [8 ] To proceed to a 5 Screen push center arrow button once.
-
Page 8: Fault Log
Screen FAULT LOG Log of all faults that have ever possibly occurred on the vehicle. The first 8 of the faults on the screen are fault checks which are created at the time the vehicle is the first programmed. button Any fault after that might be relevant. - Page 9 Note: You will see a sequence fault if not started in neutral this code will clear as soon as you put the car in neutral. The vehicle will possibly give you a cut back code. When the vehicle gets low on power it will automatically cut back, this is a safety precaution to protect the motor and controller.
- Page 10 American Custom Golf Cars, Inc. 15740 El Prado Rd. Chino, CA 91710 USA (909) 597-2885 (909) 597-7183 fax www.acgcars.com © Copyright 2009-2013 American Custom Golf Cars, Inc. Page 10 Copyright © 2009-2013 American Custom Golf Cars, Inc.
Need help?
Do you have a question about the SEVCON and is the answer not in the manual?
Questions and answers