Download Print this page

Maintenance And Cleaning - IME Hurrican I Operating Manual

Ime convection ovens

Advertisement

Maintenance and
Following references are absolutely to be considered at all maintenance and
-
Before beginning the maintenance- resp. cleaning jobs disturb power supply and let
chill device,
-
Never dump into water and do not clean with high pressure devices (Pressurized water
jet),
-
employing only detergents which correspond to the food laws,
-
Maintenance and repair
Wiring, electric component and electrical heating elements can
substitution of the same ones is to proceed as follows :
Stove light:
Heating element:
Fan:
Switching units:
Seals:
Cleaning
For a
long
service life it is important to subject the apparatus to a general
according to the following recommendations:
The parts from stainless Stole must be cleaned with standard, suitable and not scrubbing
product
Not to employ chlorous products under any circumstances (corrosive detergents etc.).
The coated and chrome-plated parts must be cleaned with a moist sponge, water and soap or
with water and a not corrosive detergent. Never employ metallic subjects or detergents with
sharp substances.
Only lukewarm water is to be employed to the cleaning of the pane of glass, however no
uneven cloths or sharp detergents. Do not clean the panes if they still are hot.
jobs
only of trained personnel
Screwing off the toecap inside in the stove; the bulb can be transposed
then.
The heating element can be removed by dissolution of the blocking -
screws inside in the cooking room; the electric connections are
after the back wall of the device was removed.
If the back wall of the device is removed, the fan protection can be
removed by dissolution of the wing screws. Through dissolution of the
left screwing - mother the wing clears and can be removed after
dissolution of the three screws of the flange-mounted motor.
They are
accessible
after the wrapper and the instrument panel were
removed.
In order to transpose the seals, the wrapper is to be removed, to loosen
the 4 screws of the seal channel then by means of a screwdriver (through
the punctures, which are
the old seal by a new.
cleaning
work
above
and below the same one) and to replace
cleaning
jobs:
defectively. For the
accessible
cleaning
regularly
Page6

Advertisement

loading

This manual is also suitable for:

Hurrican iiTornado