Assembling And Adjustments; General - Husqvarna TS 60 Operator's Manual

ASSEMBLING AND ADJUSTMENTS

General

• Mount the frame legs together using the bolts. The legs
can be folded together for easier transport.
• Adjust the working height by releasing the spring loaded
quick connector and slide the inner tube to wished height.
• Lift the saw on the stand. The slot on the saw must be
aligned with the groove on the stand.
Use the two clamps, one on each side, to fasten the frame on
to the stand.
• Pull out the locking knob on the conveyor cart.
• Slide the conveyor cart onto the frame. Make sure that the
support rollers sit correctly in the slot.
• When the locking knob past the lug on the frame, push the
locking knob in to allow the conveyor cart to slide all the
way in.
• Fit the side table using the supplied screws.
If the side table is not in level with the conveyor cart it may
need adjustment. Adjust using the screws.