Prolight Equinox Bounce User Manual

Advertisement

Quick Links

BOUNCE
order code: EQLED41

user manual

w w w . p r o l i g h t . c o . u k

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Equinox Bounce and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Prolight Equinox Bounce

  • Page 1: User Manual

    BOUNCE order code: EQLED41 user manual w w w . p r o l i g h t . c o . u k...
  • Page 2: Safety Instructions

    Equinox Bounce Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
  • Page 3: Operating Determinations

    Leave the equipment switched off until it has reached room temperature. • If your product fails to function correctly, discontinue use immediately. Pack the unit securely (preferably in the original packing material), and return it to your Prolight dealer for service.
  • Page 4 Equinox Bounce Technical specifications You should find inside the Equinox carton the following items: 1, Equinox Bounce 2, Power cable 3, Instruction manual Technical Specifications: DMX channels: 4 Voltage: AC 110-240V ~ 50Hz/60Hz 84 Ultra bright LED’s (R: 24, G: 24, B:18, W:12, Y: 8)
  • Page 5: Other Functions

    Equinox Bounce Functions Other functions Slave Mode To set the unit in the Slave mode, press the “MODE” button to show “Func” in the LED display window. Now press the “SET UP” button and use the “UP” and “DOWN” buttons to show “Slav”...
  • Page 6 DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Bounce can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
  • Page 7 Equinox Bounce DMX Set up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.
  • Page 8 w w w . p r o l i g h t . c o . u k...

Table of Contents