Gps Maps On A Microsd Card; Answering Calls While Using Gps - Catchwell CW30 User Manual

Though there is a default setting, it is subject to change.
It may take from a few seconds to several minutes before receiving satellite signals. The outdoor location where
there are no obstacles blocking the sky is ideal. If such a location is not available, it may take longer time to receive
the signals or CW30 may be unable to calculate the initial position quickly. In case of indoor use, the access to GPS
signals may be restricted or impossible.
When you using a GPS navigation program, make sure CW30 is not switched to temporary pause
mode. If CW30 is in temporary pause mode, power to the GPS module will be cut off. To continue to
use GPS, the GPS receiver has to search for effective GPS signals again; as a result, the retrieval of
location information will be delayed.
There are GPS navigation software vendors who are selling GPS maps on microSD cards. In case of using microSD
for navigation software:
1
Remove the battery from CW30.
2
Push up the SD card slot located inside the battery compartment at the back of PDA to the right.
3
Insert the SD card into the slot.
4
Push the slot where SD card is inserted to the left by pulling it down.
When there is an incoming call while using a GPS navigation program:
1
Tap Answer button to receive the call.
2
After nishing the call, tap Talk End button to restart the audio of GPS software.
When receiving incoming calls while using GPS on CW30, the GPS navigation software will be muted
until the call is nished
76