Clicker K1 Instructions

PLEASE FOLLOW ALL INSTRUCTIONS IN THE ORDER THEY ARE PRESENTED
STARTING WITH THE "INTRODUCTION".
Congratulations! The Clicker Model K1 you have purchased is one of the most unique
keypad transmitters available. The K1 works in conjunction with most Stanley, Linear,
Multi-Code and Moore-O-Matic garage door operator systems. In order to identify your
brand look for the company name on your existing transmitter or garage door operator.
The KI transmitter can be programmed to operate one or two garage doors. It is pos-
sible to program the system to replace the 8 position Linear and 10 position Stanley
Multi-Code type transmitters through the use of separate PIN numbers.
All the information that the keypad system needs for proper operation is programmed
through the keyboard. The K1 system will not operate until it is properly programmed. It
is therefore important that each instruction be followed in the order presented.
STEP 1:
NOTE: During the programming it is necessary to wait 30 seconds between each step.
This is a normal part of the setup of the K1 keypad transmitter.
Press any number on the keyboard. The keyboard should light up and remain illumi-
nated for approximately 6 seconds. If it does not light up refer to the BATTERY RE-
PLACEMENT section and check to make sure that the battery is properly connected.
Wait 30 seconds before proceeding to the next step.
STEP 2: PROGRAMMING YOUR PIN NUMBER FOR DOOR ONE
A. Pick any 3 numbers you can remember. (Use any combination or any order of
three numbers you desire.)
B. Follow each step carefully:
(1) Press the numbers 1, 2 & 3
(2) Press the "*" key
(3) Press the three numbers you want as your PIN number
(4) Press the "*" key again
(5) Wait 30 seconds before proceeding to the next step
EXAMPLE: Press 1,2,3, press *, press XXX (your PIN number) press *.