Table of Contents
Advertisement
TIPS
A. install the batteries into the unit.
B. When batteries are first installed on both the scale and remote display unit.
B-1. acquire the weight on the scale.
B-2. match the remote display unit with the scale.
Note:
a) beep sound indicates that the matching is activated.
b) check the reading on the scale and the remote display unit .
c) if this fails, repeat step B-1 & B-2.
B-3. set the clock.
C. after changing batteries of the scale, repeat steps B-1 & B-2.
D. after changing batteries of the remote display unit, set the clock.
E. replace all batteries when
F. replace battery when
G. memory stored in remote display unit will not be ereased after changing the batteries.
H. if the unit malfunctions or operates irregularly, press reset on the scale and then repeat step B-1 & B-2.
Note:
a) place a blunt stylus into the slot to press reset.
b) after reset please wait for few seconds for the scale to self-calibrate.
I. allow the scale to settle for around 30 min if there is a sudden change in environment . eg. from
an air conditioned room to an open area.
If not disposed of properly, batteries can be harmful. Protect the environment by taking
exhausted batteries to authorized disposal stations.
To extend battery life, when battery power is low, replace all the batteries.
J. If there exists irregularity in the remote display unit, press reset on the unit to reset it.
Bwr102AE.p65
appears on the scale.
for scale or
for remote display unit appears on remote display unit.
5
5
05/22/2002, 7:32 PM
Advertisement
Table of Contents
