Advertisement
WARNING
!
Read the Owner's Manual thoroughly before using your FitSpine Trainer inversion table.
Improper settings could result in serious injury or death!
If you have any problems assembling the equipment,
or questions about its use, please contact customer service at:
STL International, Inc.
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(e-mail) info@FitSpine-System.com (web) www.FitSpine-System.com
U.S. patents apply.
FitSpine™ is a registered trademark of STL International, Inc.
Specifications subject to change without notice.
© COPYRIGHT 2009, STL International, Inc.
International Law Prohibits Any Copying, 0610-3
LS-2001
Assembly Instructions
Want more information about your FitSpine refer to the:
1. Owner's Manual
2. Contact Customer Service at 1-800-847-0143
3. Visit www.FitSpine-System.com
Advertisement
Table of Contents
Summary of Contents for FitSpine Inversion table
-
Page 1: Assembly Instructions
Assembly Instructions WARNING Read the Owner’s Manual thoroughly before using your FitSpine Trainer inversion table. Improper settings could result in serious injury or death! Want more information about your FitSpine refer to the: 1. Owner’s Manual 2. Contact Customer Service at 1-800-847-0143 3. -
Page 2: Important Safety Instructions
• Close supervision is necessary when the inversion table is used near children, or by or near invalids • Pull up on the plastic tension clips to loosen the adjustment or disabled persons. -
Page 3: Items For Assembly
Bolts & Nuts (2) IA-1148 card, or submit it online at www.fitspine-system.com Support Handle Shrouds FS-1025 Hex Bolts (4) H1-1202 FS-1052 F5-1051 F5-1056 Roller Hinges F5-1064 Wrenches F5-1088 Owner’s Manual FS-1040 IA-1148 FS-1025 H1-1202 Figure 19 F5-1088 F5-1064 FitSpine Trainer FitSpine Trainer... - Page 4 Step Eight Before reading further, study the drawing below to familiarize yourself with the important Install the Support Handles (FS-1040) components of your inversion table. in the A-frame (FS-1010) and attach the Support Handle Shrouds (FS-1025) • Insert the Support Handles into the A-frame (Figure 15).
- Page 5 • Insert the screw (IA-1123) into the Foot Platform (Figure 14) and tighten with the screwdriver (F5-1130) provided. Note: Refer to the Owner’s Manual for a (Back) description of the settings. Figure 14 Showing “Low Setting” (Front) Figure 2 FitSpine Trainer FitSpine Trainer...
- Page 6 Check Figure 11A to make sure that the self-locking hooks have closed over both pivot pins (Figure 7), and the table rotates smoothly. Figure 11B Figure 6 Figure 7 FitSpine Trainer FitSpine Trainer...
Need help?
Do you have a question about the Inversion table and is the answer not in the manual?
Questions and answers