Table of Contents
Advertisement
Quick Links
IMPORTANT:
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER
These instructions are supplementary to the Installation
and Operating Instructions supplied with the fireplace
and should be kept together. Refer to the Installation
and Operating Instructions for proper gas supply, safety
requirements and operating instructions.
140708-16
TC30.NG01.C
TC30 CHALET
BURNER KIT
INSTRUCTIONS
PART# TC30.NG01.C
For TC30 Series C
5056.429.01
Advertisement
Table of Contents
Related Manuals for T&C TC30
Summary of Contents for T&C TC30
- Page 1 Operating Instructions supplied with the fireplace and should be kept together. Refer to the Installation and Operating Instructions for proper gas supply, safety requirements and operating instructions. TC30 CHALET BURNER KIT INSTRUCTIONS PART# TC30.NG01.C For TC30 Series C 140708-16 TC30.NG01.C 5056.429.01...
- Page 2 Notes TC30.NG01.C 140708...
-
Page 3: Contents Of Package
NOTE: Primary air shutter must be fully closed for Natural gas or fully open for Propane. Attach the manifold supply tube to the Fig #2 bulk head fitting and tighten. (Fig. # 2) Ensure that there are no leaks. TC30.NG01.C 140708... - Page 4 (Fig. # 5) If appliance is to used with propane gas see propane conversion instructions on page #6 before proceeding. Fig #6 Attach air deflector to rear of grate with two screws (Fig. # 6) TC30.NG01.C 140708...
- Page 5 Ember material placement and amount will affect flame appearance. More ember material results in lower flame height. Add or remove as needed until desired flame affect is achieved. Reduce the amount used on Propane models, as too much will create soot. TC30.NG01.C 140708...
- Page 6 The remaining logs do not have holes or pins. They rest in position. Locate as per the diagrams. (Figs. #8 – #18) Fig #9 Fig #10 PIN HOLE BASE LOG #1 Fig #12 Fig #11 PIN HOLE TOP RIGHT LOG #2 TC30.NG01.C 140708...
- Page 7 Fig #13 Fig #14 PIN HOLE TOP LEFT LOG #3 Fig #16 Fig #15 BOTTOM RHS CHUNK #4 BOTTOM CENTER CHUNK #5 Fig #18 Fig #17 BOTTOM LHS CHUNK #6 CENTER CHUNK #7 TC30.NG01.C 140708...
-
Page 8: Propane Conversion
Fig #22 The gas supply and electrical power With a ½” wrench remove the natural gas shall be shut off before proceeding orifice (#32) and replace with propane orifice (#48)(our part # 5021.3407) with the conversion. (Fig. #22) TC30.NG01.C 140708... - Page 9 Minimum A groove on the screw body will be rate screw visibe just above the valve body. Insert a thin tool (knife blade or thin screwdriver blade) into the groove and gently pry the screw up. TC30.NG01.C 140708...
- Page 10 Fig #32 16. Attach the access panel to the side of the firebox with the previously removed screws. (Fig. #32) Note: Gasket must be installed with access panel. TC30.NG01.C 140708...
-
Page 11: Gas Pressure Check
Correct gas pressure requirement: Supply Pressure Natural Gas Propane Min. Pressure 5.0" WC 12.5" WC (For purpose of input adjustment) Max. Pressure 13.9" WC 13.9" WC Manifold Pressure Maximum 3.8" WC 11" WC Minimum 2.1" WC 5.5" WC TC30.NG01.C 140708... -
Page 12: Burner Flame Adjustment
Remove air deflector from log grate (2 screws) It should NEVER be set to create sooting on internal parts and glass. Loosen the Primary Air Shutter screw. Rotate the shutter to increase or decrease the amount of primary air. Reassemble in reverse order. TC30.NG01.C 140708... -
Page 13: Replacement Parts
(WHEN ORDERING, INCLUDE PART NUMBER WITH DESCRIPTION) ITEM ..DESCRIPTION ..........PART NO. ITEM ..DESCRIPTION ..........PART NO. #4..PILOT ASSEMBLY ......5005.025 #1..CHALET BURNER ASSEMBLY ..TC30.NG01.C #5..MAIN SUPPLY TUBE ......5019.223 #2..7 PCS LOG SET ......... 5098.746148 #6..PILOT TUBE ........5019.225 #3.. - Page 14 Notes TC30.NG01.C 140708...
- Page 15 Notes TC30.NG01.C 140708...
- Page 16 Technical support: 1-877-715-2664 Web site: www.townandcountryfireplaces.net 2975 Allenby Rd., Duncan, BC V9L 6V8 Printed in Canada...