Advertisement
12. VOLTAGE SELECTOR
Slide voltage selector to the left or right,
for
selecting
necessary
Voltages level is marked on the selector.
Before selecting voltage, make sure that
loudspeaker is disconnected from the
main power.
13. POWER SWITCH
Press the button for turning on/off.
Please make sure that all loudspeakers
volume controls are set to min
positions, before turning on.
Player
1. POWER AND PLAY/PAUSE
BUTTONS
By pressing POWER key, the unit is
switched on or off. PLAY/PAUSE key
starts playing and change player's
mode between play and pause.
2. VOLUME CONTROL
Volume control of the player. Please
note: Total music player's volume
depends from player's volume
control
potentiometers,
volume control buttons on the
player and master potentiometers.
3. USB slot
Slot for USB flash drive.
4. IR receiver
Receives
the
commands
remote control.
Remote control
All music player's functions can be controlled by IR remote control.
Because of the IR receiver's location, IR remote control should be
directed to the rear panel in order to guarantee a reliable remote control
operation.
14. FUSE HOLDER
voltage.
15. PLAYER VOLUME CONTROL
form
from
Use T2AL 250V fuse only. Contact
with qualified service personnel if
fuse blows up constantly.
Volume control of the player. Please
note: Total music player's volume
depends
from
player's
control
potentiometers,
volume control buttons on the
player and master potentiometers.
5. REPEAT AND EQ BUTTONS
There are available two modes of
repeat, ONE REPEAT and ALL
REPEAT. Press repeat key, to set
repeat mode.
Press key to change EQ mode
cyclically.
NORMAL
JAZZ
ROCK
→
→
CLASS
6. NEXT AND PREVIOUS BUTTONS
Single press of this button changes
the track to next or previous track,
according to which button, NEXT or
PREVIOUS, was pressed.
7. SD/MMC SLOT
Slot for SD or MMC card.
volume
form
POP
→
→
Advertisement
