Installation Dimensions – Monica Plus Freestanding 7,48in 190mm 18,07in 1,69in 459mm 43mm 20,01in 508mm Refer to Safety Test 09/1910 for all clearances to combustible.
Installation Clearances & Specifications Minimum clearances shown are in millimetres. All Ecoteck fires are tested to AS/NZS2918:2001. Specifications were correct at time of printing but may alter and those detailed below should be used as a guide only. Refer to the Installation and Operation Manual supplied with every Ecoteck Pellet Fire or if in doubt, consult your Switch Retailer.
Page 4
Location of the Pellet Fire Installation of the Ecoteck Monica Plus Freestanding Wood Pellet Burning Heater should be undertaken by an experienced installer. Please read the Monica Plus Owners/Technical Manual thoroughly before commencing installation as failure to follow the instruction could cause damage to the pellet fire or property.
Page 5
Internal Standard Flue Kit Internal Standard Flue Kit (50) This ue kit may be used in new and replacement applications in rooms with stud height of 2.4m. The overall height of the ue is 3.6m. The visible u e is nished in black and the ceiling plate is white.
Page 6
External Standard Flue Kit External Standard Flue Kit (51) This ue kit may be used in new and replacement applications with the ue penetrating the wall behind the re, running vertically up an outside wall and penetrating the so t. The overall height of the f lue is 3.6m.
Flashing Options Decktite - For all Steel Roof Profiles Please circle the flashing option to be used. When considering an alternative method please consult your local council. Seismic Restraint All installation scenarios for Monica Plus require the use of hold-down anchors (one on each side) Fixing to Concrete Floor Minimum M8 expansion anchors (M10 recommended) or min M8 epoxy- set anchors.