Appendix A - Setup Procedure - Rojone EziTraK Installation Manual

7.0

APPENDIX A - SETUP Procedure

The EziTraK™ is easily Set Up using a simple procedure outline below.
1. Remove all power fro m the unit including the backup battery.
2. To access the Front Panel and remove the screws, simply cut the cable ties on the box and cable entry boots.
Place some silicon grease along the cable behind the 3 cable boots. Then carefully SLIDE the Inner plastic
boot back over the cables about 2 inches (50mm) to expose the front panel connectors.
Do NOT remove any connectors from the front panel.
Do NOT at any time remove the Rear Panel and attempt to remove the circuit board.
Check that the front panel cables and connectors are correctly mated and ensure that the Inner plastic boot is
sitting securely over the front panel and connectors.
3. Unscrew the 4 front panel screws and carefully slide out the main circuit board.
TEL +61 02 9829 1555 FAX 02 9605 8812 EMAIL sales@rojone.com.au
ROJONE Pty. Ltd – 61 Aero Rd, INGLEBURN NSW 2565 AUSTRALIA
19