Page 2
1. Introduction This manual is designed to guide you in the use and care of the iBill Talking Banknote Identifier. This specially designed unit identifies and announces the denomination of U.S. banknotes. 2. Getting familiar with the iBill Orientation of the unit and its Controls This section will familiarize you with the location and functions of the controls.
Page 3
Once the battery cover is open, you will find a silk cloth strip which aids in removal of the battery. The old battery can be extracted by pulling on this silk strip. When inserting a battery, this strip should go around the underside of the battery.
Page 4
Event Speech Mode Tone Output Vibration Mode Announce Single beep of ”One” Short pulse $1 bill low pitch Announce Two beeps of ”Two” Two short pulses $2 bill low pitch Announce Three beeps of Three short ”Five” $5 bill low pitch pulses Announce Single beep of...
Page 5
3. Using the iBill Identifying a Bill To switch on the unit, press either of the two push-button switches. Turn- on is indicated by a short beep or vibration pulse. The unit begins the identification process and when complete, announces the denomination of the bill (or indicates an un-identifiable bill).
Page 6
performed, the denomination of the bill is announced when both buttons are released. The unit turns itself off automatically after completion of bill identification or a volume or mode change. Canceling the current identification cycle Once the identification cycle has begun, you may wish to cancel the current cycle and restart it due to several reasons, for instance, realizing that the bill was not properly inserted, or if the identification is taking long due to poor condition of the bill.
Page 7
Low Battery Indication The unit continually monitors the battery level during use. A warning is provided when remaining capacity battery reaches approximately 10% of the full capacity. The warning is in the form of two short beeps of high and low pitch in Speech and Tone Modes or three very short vibration pulses and is provided at the end of each denomination announcement.
Page 8
4. Care of the device The unit should be protected from dust and liquids. When not in use, keep the unit in a protective water and dust-proof case. Periodically wipe the unit with a slightly damp, soft, lint free cloth to remove accumulated dust, especially from the area near the bill insertion slot.
Page 9
6. Warranty and Repair Orbit Research provides a one-year limited warranty for the iBill Talking Banknote Identifier from the original date of purchase. The warranty covers all manufacturing defects as well as all parts and related workmanship.
Page 10
Orbit Research reserves the right to change product specifications without notice. Any modifications or upgrades to products previously sold will be performed solely at the discretion of Orbit Research. The latest version of this user guide can be found at the Orbit Research website www.orbitresearch.com.
Need help?
Do you have a question about the iBill and is the answer not in the manual?
Questions and answers