Summary of Contents for ecoteck Amalfi
- Page 1 Ecoteck Amalfi Freestanding Wood Pellet Burning Heater Installation Specifications Safety testing of the EcoTeck Amalfi Freestanding Wood Pellet Burning Heater to AS/NZS 2918:2001 Report 09/1910...
-
Page 2: Installation
Specifications were correct at time of printing but may alter and those detailed below should be used as a guide only. Refer to the Installation and Operation Manual supplied with every Ecoteck Pellet Fire or if in doubt, consult your Nature’s Flame Retailer. - Page 3 Location of a power source • Amalfi has a convection fan which blows air through tubes in the direction that the fire faces, for optimum performance this location should be in a large room centrally located. •...
- Page 4 Pellet Fire Flue Kits Internal Standard Flue Kit (50) Internal Standard Flue Kit This flue kit may be used in new and replacement This ue kit may be used in new and replacement applications in rooms with stud height of 2.4m. applications in rooms with stud height of 2.4m.
- Page 5 Pellet Fire Flue Kits External Standard Flue Kit (51) External Standard Flue Kit This flue kit may be used in new and replacement applications with the flue penetrating the wall This ue kit may be used in new and replacement behind the fire, running vertically up an outside applications with the ue penetrating the wall behind wall and penetrating the soffit.
-
Page 6: Flashing Options
Please circle the flashing option to be used. When considering an alternative method please consult your local council. SEISMIC RESTRAINT: All installation scenarios for Amalfi require the use of hold-down anchors (one on each side) Fixing to Concrete Floor: Minimum M8 expansion anchors (M10 recommended) or min M8 epoxy- set anchors.
Need help?
Do you have a question about the Amalfi and is the answer not in the manual?
Questions and answers