Table of Contents
Advertisement
Appendix A:
General Application Information
This chapter provides additional information on standard factory default settings, access modes,
Smart CLI and any special network or product considerations.
Command Access Modes
Access to Supervisor Mode or Admin Mode is password protected. The show supervisor
command displays the current state of Supervisor Mode (enabled or disabled) and Admin Mode (on
or off).
•
The enable command prompts for entry of the Supervisor or Admin password.
Once Supervisor or Admin mode is enabled, the help screens will display the additional
commands made available by those modes.
•
The disable command returns the console to normal USER mode.
Factory defaults for user accounts are:
The first two usernames are admin and supervisor. These cannot be deleted, but their
passwords should be changed before placing the unit into operation. Note that admin and
supervisor cannot be used as username logins. They are only used to enable the supervisor/
admin mode. The only default username login is defined as gdc with the password gdc. This
username may be deleted or its password should be changed.
Up to twenty usernames/passwords may be configured after supervisor. Use the configure
accounts add command string to add new usernames and passwords, or modify existing
passwords.
When the enable command is used, the password entered is first compared to the Admin
password and then to the supervisor password. This allows users with knowledge of the Supervisor
password to enter Supervisor Mode and configure all parameters except for user accounts. Only
users with knowledge of the Admin password can enter Admin mode and add/modify user accounts.
With factory default configuration, console authorization is turned off. That is, username/password
login is not required to enter user mode from the console port. Console authorization may be turned
on in Admin mode by the configure accounts console enable command string. For
Telnet connections, username/password login will always be required.
200R204-000
Issue 2
Application Guidelines
User Name
admin
supervisor
supervisor
gdc
Innovx FastSwitch Ethernet Switch
Installation and Operation Manual
Password
admin
gdc
A-1
Advertisement
Table of Contents
