Installing The Flag Masts; Before Running Your Vehicle - Vaterra glamis Fear Owner's Manual

insTalling The Flag masTs

beFore running your VehiCle

CauTion: Do not discharge
a Li-Po battery below 3V per cell.
Batteries discharged to a voltage
lower than the lowest approved
voltage may become damaged,
resulting in loss of performance
and potential fire when batteries
are charged.
12
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
1 Remove the 4 body clips to remove the side panels.
2 Turn the vehicle over so the bottom faces up and remove
the 4 screws in the corners of the chassis to remove the
roll cage.
3 Install the flag mast in the flag mast hole.
4 Install the setscrew using the 1.5mm hex wrench.
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
1 Break in the differential. While holding the chassis with only
the left rear tire firmly on the ground, give the vehicle about
1/8 throttle for 30 seconds. The right rear tire should spin
freely during this time. Do this with only the right rear tire
firmly on the ground, allowing the left to spin freely.
Repeat this 2–3 times.
2 Check for free suspension movement. All suspension
arms and steering components should move freely.
Any binds will cause the vehicle to handle poorly.
3 Charge the battery.
4 Check the calibration of the ESC. If recalibration is required,
follow the setup instructions.
5 Adjust the transmitter settings to your desired configuration.
PoWerinG on the Vehicle
Power ON the vehicle by pushing the switch towards the rear.
Power OFF the vehicle by pushing the switch forward.