flopower FLOW160DA000 Operator's Manual And Parts List page 6


Replace or repair all worn or damaged parts.

Disconnect the power source before performing any service or repairs.

Read and follow all the instructions in this Operator's Manual.
FIRE AND EXPLOSION:
Fire and explosion can be caused by hot slag, sparks, or the welding arc.

Be sure there are no combustible or flammable materials and gases in the work area. Any material that cannot be removed must be protected.

Ventilate all flammable or explosive vapors out of the weld area.

Do not weld on containers that may have held combustibles.

Provide a fire watch when working in an area where fire hazards may exist.
WELDING RAYS:
The welding process produces very bright ultraviolet rays. These arc rays can damage your eyes and burn your skin if you are not properly protected.

To protect your eyes, always wear a welding helmet or shield. Also always wear safety glasses with side shields, goggles or other protective eye wear. The protective shade must be number 10 or higher for
welding up to 160A.

Keep helmet and safety glasses in good condition. Replace lenses when cracked, chipped or dirty.

Wear welding gloves and suitable clothing to protect your skin from the arc rays and sparks.

Protect others in the work area from the arc rays. Use protective booths, screens or shields.
DUAL VOLTAGE WARNING: This unit is a dual voltage machine, and can be used both with 110VAC and 220VAC input power. It is very important to select the correct welding voltage in the machine according to the
power circuit being used. Failure to do so may result in electric shock, fire, harm to you and damage to the machine.
For a list of publications and documents which can help you adopt correct operating procedures and avoid harmful actions, please consult the section "REFERENCE PUBLICATIONS" at the end of this manual.
6 User Manual 160 DualArc ENG
FLOW160DA025