Kogan kaled55 series User Manual page 25

1. Video may become pixelated if the video bit rate is too high for your USB drive, especially during recordings
of high-definition material. If this occurs, try using a faster USB drive, or re-format it using the High Speed
Format option. Note:This may make the drive un-readable in other USB devices.
2. The USB PVR function relies on the use of high quality USB 2.0 drives, and as such may not be compatible
with some specific USB devices, for example, low-cost USB flash-drives with slower memory components,
and some USB 3.0 flash-drives (operating in USB 2.0 mode) may not be compatible with this TV. Also, USB
hard-drives need to be low power versions (eg. portable types), or must be used with an external power
source to prevent overloading the USB socket on the TV.
10. Timeshift function
Prepare to record the program
This TV allows you to pause and record the currently watched digital TV program to a USB storage device,
and to resume viewing at the point where it was paused.
NOTE:
Formatting a USB 2.0 storage device will be needed. Save the original data on your USB device before
formatting. All the data stored in the USB device will be erased after formatting.
USB Drive Storage Format
Follow the Format instructions on page 20 of this Manual to format the USB device and allocate the
amount of space for the Time Shift function.
NOTE:
The format process will take at least 2 minutes depending on the capacity of your USB device. Please do
not turn off the power or remove the USB device during formatting. The High Speed format option is
recommended for better HDTV recording results.
During formatting, a speed test will be done on the USB device. If it fails, it means the USB device may
not support the Time Shift function.
Record a paused DTV program to USB storage device
1. While in the DTV input source, check that your USB storage device is plugged into the USB port on
the side of your TV.
2. Select a DTV channel, then press PAUSE to start the Time Shift function. The TV program will be
paused on screen; the Time Shift OSD appears and recording commences. Press
time-paused material.
3. Press STOP to stop the Time Shift function and stop recording program.
Pause
NOTE:
Please do not unplug the USB storage device when the Time Shift function is activated, as damage to the
recorded file or the USB storage device may occur. Approximately 4GB of memory buffers about 30-40
minutes of DTV material.
1.Video may become pixelated during recording when the Video bit rate capability of your USB device
is too low. If this occurs, try using a higher speed USB drive or reformat the drive using the High Speed
format option.
2.The USB Timeshift function relies on the use of high quality USB 2.0 drives, and as such may not be
compatible with some specific USB devices.
Play FB
Stop
-25-
PVR OPERATION
play to playback the
FF Prev. Next
Pause
00:00:33/00:04:22
Stop