Advertisement
Quick Links
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET
INSTALLATION AND OPERATING INSTRUCTIONS
LEAVE THIS DOCUMENT WITH THE HOUSEHOLDER!
EN 13229
Manufactured for Rectella International Ltd, Bancroft Road, Burnley, Lancs, BB10 2TP
Read these instructions! Use only recommended fuels!
(Measurements include decorative frame)
Intermittent burning solid fuel room heater for installation in
masonry fireplace with a single dedicated chimney.
Approx. efficiency
Nominal Output
Minimum clearance to
combustible materials
Must be maintained
Web:
Wood logs
78%
4.9Kw
Top: 400mm
All other faces: 250mm
Tel: 01282 478200
www.barbequick.com
1
BQ2104-1d
1622 Instove
INSET
INSET SOLID FUEL
ROOMHEATER
FOR INSTALLATION IN
STANDARD BRITISH or IRISH
FIREPLACES CONFORMING TO
BS1251 & BS8303
Mineral fuel (Ancit)
76%
3.0kW
Oct 2011
Advertisement
Summary of Contents for Rectella 1622 Instove INSET
-
Page 1: Installation And Operating Instructions
Nominal Output 4.9Kw 3.0kW Minimum clearance to Top: 400mm combustible materials All other faces: 250mm Must be maintained Manufactured for Rectella International Ltd, Bancroft Road, Burnley, Lancs, BB10 2TP Tel: 01282 478200 Web: www.barbequick.com Read these instructions! Use only recommended fuels! - Page 2 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Contained in this box are the following components 1 x Sealing rope 1 x Double sided sticky tape for fixing the sealing rope 4 x Stove securing bolts and washers 1 x Flue collar...
-
Page 3: Installation
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET IMPORTANT Co2 DETECTOR It is the responsibility of the installer to fit a fully operational Co2 detector in the same room as this appliance. INSTALLATION THIS APPLIANCE CAN PRODUCE POISONOUS GASES IF NOT FITTED CORRECTLY. - Page 4 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET FITTING: Referring to Fig 6, 7 and 8, peel off one side of the protective film and apply the double sided tape to the rear of the stove edges (as in Fig 6) pressing down firmly to make sure of good adhesion, then peel away the second side protective film and apply the soft rope seal to the sticky double sided tape (Fig 7) with a finished rope seal all the way round (Fig 8).
-
Page 5: Check The Installation
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Primary air slider – Assemble the slider from the inside of the door. Push the slider bar bolt through the hole in the door and then tighten the slider knob ensuring that the slider is free enough to slide back and forth. Make sure that the slider slides and that the air holes line up. - Page 6 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET OPENING THE DOOR This stove is designed to be operated only with the door closed. Open the door very slowly to minimise fume mission and prevent hot fuel falling out. FUELS There is no 'perfect' fuel, so we strongly recommend that you try a selection of fuels (or mixtures) to find which suits you best.
- Page 7 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET Operation to Avoid Smoke Emission when Loading and Re-lighting To prevent the likelihood of smok e emission it is advised that: The appliance is not overloaded Fuel should be added to fill the stove c riss-cross, so air can circulate between logs.
-
Page 8: Maintenance
Installation and Operating Instructions Reference: 1622 Rectella Instove INSET MAINTENANCE ANNUALLY- SWEEP THE CHIMNEY The entire length of the chimney from stove to outlet should be swept annually or more often if smoky fuels are used. SUMMER SHUT DOWN: Before a long period of non-use, empty fuel and ash, remove the throat plate and leave all the air controls open to allow ventilation to reduce condensation. - Page 9 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET ORDERING NEW PARTS – Please use the item list below whenever you need to order. ITEM NO. PART NUMBER DESCRIPTION 1622-015 TOP FLUE RING INTEGRA-002 DOOR FRAME 2040-280 DOOR LATCH A...
- Page 10 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET TO FIND A QUALIFIED INSTALLER, FUEL SUPPLIER or CHIMNEY SWEEP, CONTACT: UK: The Solid Fuel Association, 7 Swanwick Court, Alfreton, Derbyshire DE55 7AS Tel:0845-601-4406 www.solidfuel.co.uk RoI: Irish Nationwide Fireplace Organisation, 162 Chapel Street, Dublin 1 Tel:01-801-5959 www.fireplace.ie...
- Page 11 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET...
- Page 12 Installation and Operating Instructions Reference: 1622 Rectella Instove INSET...
Need help?
Do you have a question about the 1622 Instove INSET and is the answer not in the manual?
Questions and answers