K&N Engineering Typhoon 69-2520 Installation Instructions

69-2520
Dodge
2000-05 Neon
L4-2.0L
Chrysler
2000-05 Neon
L4-2.0L
Tools
Flat Blade Screwdriver
Phillips Screwdriver
Ratchet
10mm Socket
13mm Socket
TO START:
1. Turn the ignition OFF and disconnect the
vehicle's negative battery cable.
2. Remove the air temperature sensor from
the stock intake tube as shown
3. Remove the wire loom from retaining clips
as shown.
4. Loosen and remove the five airbox retaining
bolts then remove airbox lid as shown.
5. Remove the stock air filter.
6. Pull up and remove the fresh air intake from
fender well.
INSTALLATION INSTRUCTIONS
7. Remove the four throttle body retaining bolts
from airbox. These bolts will be re-used.
8. Remove the crankcase vent hose from airbox as
shown.
9. Remove the bolt and nut that secure the the
airbox to the vehicle. Bolt will be re-used.
10. Remove the airbox from the vehicle.
11. Jack the driver's side of the vehicle up and
support with jack stands then remove the tire.
WARNING: Please follow directions carefully. The K&N
Drycharger, included, must be installed on the K&N air filter
in all K&N Typhoon Cold-Air intake kits. The K&N Typhoon
Intake System is a performance product that can be used
safely during normal, ambient weather conditions. During
harsh and inclement weather conditions, you must convert
your Complete Cold Air Intake System to a Short-Ram con-
figuration, or return your intake to the stock OEM airbox
and intake tract configuration. Failure to follow these
instructions can void your warranty.
Parts list
Description
A HOSE CLAMP #44
B HOSE; 2-1/2"ID X 2"L, STRAIGHT, BLACK
C BRACKET; "F" THROTTLE
D BRACKET; "F" RADIATOR
E GROMMET; ATS
F TUBE; 69-2520, POLISH
G VIBRATION GROMMET
H WASHER; 8MM FLAT, SS
I NUT; 6MM NYLOCK, SS
J HOSE CLAMP #40
K FILTERCHARGER
L DRYCHARGER (BLACK)
M WRENCH; T20 TORX
O EDGE TRIM
P HOSE; 10MM X 22"L, BLACK SILICONE
12. Using the supplied T-20 wrench, remove
the two screws that retain the inner fender
valance to the fender.
13. Remove the two push pins that retain the
inner fender valance and move out of the way.
14. Remove the two bolts that retain the resonator
to the fender well then remove the resonator.
Qty. P/N
2 08560
1 08441
1 070063
1 070062
1 08167
1 27131TP
1 082002
1 08272
1 07512
1 08554
1 KRU4950E
1 971001DK
1 69801
1 102455
1 084060