Table of Contents
Advertisement
Quick Links
GUMOTEX, akciová společnost
Mládežnická 3A, č. p. 3062
690 75 Břeclav
Plant: Dongguan Yueli Toys Co.,Ltd,
China
Inflatable child restraint system the GOBOOSTER child car seat (type BEDI)
The solution of the child restraint system of BEDI type (trade name GOBOOSTER) is
protected by the Czech patent No. 302787 and at the same time by the Community (industrial)
The owner of the patent and of the Community (industrial) design is the company
GUMOTEX, akciová společnost, Mládežnická 3A, č. p. 3062, 690 75 Břeclav
The child restraint system non-integral, approved according to the
Universal group for children with the weight (15 – 36) kg from the age of approximately 3
It is designed for motor vehicle cars equipped with the adult safety-belts
which are approved according to the Regulation UN ECE No. 16
1. The universal child restraint system is approved according to the Regulation UN ECE
No. 44, series of amendments 04 for the common use in vehicles.
The length of vehicle safety belt at the older vehicles has not been checked and there-
fore it is possible to meet a vehicle in which the BEDI (trade name GOBOOSTER)
restraint system cannot be used.
2. The proper use can be expected provided the vehicle manufacturer declares in the
service instructions the possibility to mount the "universal" child restraint system in
the vehicle.
3. In doubts concerning the use or installation of the BEDI child restraint system consult
either the dealer or the manufacturer of the BEDI child restraint system directl
Instructions for Use
User´s Manual
design No. 001860222-0001.
Regulation UN ECE No. 44.04
years and height up to 150 cm
NOTICE
1
Advertisement
Table of Contents
Summary of Contents for Gumotex child car seat
- Page 1 No. 44, series of amendments 04 for the common use in vehicles. The length of vehicle safety belt at the older vehicles has not been checked and there- fore it is possible to meet a vehicle in which the BEDI (trade name GOBOOSTER) restraint system cannot be used.
-
Page 2: Table Of Contents
8 Inflation and deflation instructions for the BEDI child car seat ........... 8 9 Installation instructions and placement of the GOBOOSTER child car seat in a vehicle ... 9 10 Basic adjustment of the GOBOOSTER child car seat for a transported child ....9 ... -
Page 3: Important Information
When reading the Manual, take the Manual of your vehicle. You may need it. The GOBOOSTER child car seat is designed and adapted in order to protect the child in the case of a sudden stop or accident. No chid car seat can guarantee the absolute protection from injury at the accident however its use reduces this risk markedly. -
Page 4: European Standards
The approval mark (circle surrounding the E ) and authorization number beginning with double digits 04 which is located below the approval mark are put on the child car seat and must not be removed. The child car seat may be used only in cars equipped with adult three-point seat belts authorized on the basis of the Regulation UN ECE No. - Page 5 The child and the child car seat may be fasted firm in a vehicle and thereby the self-motion aside during the vehicle ride is prevented. If the firm fastening is unpleasant for your child, then the GOBOOSTER child restraint system is not suitable for your child.
-
Page 6: Gobooster Child Car Seat Parameters
6 years , up to 150 cm Description of the GOBOOSTER child car seat The child car seat has been made from two basic parts – seat (1) and backrest (2) which are connected after inflation into a single-chamber body anatomical formed for a seating child. - Page 7 Safety instructions (16) in the side seam o the GOBOOSTER child car seat. Fig. 1 Front, side, top and rear view of the GOBOOSTER child car seat Front view Side view Top view Rear view...
-
Page 8: Inflation And Deflation Instructions For The Bedi Child Car Seat
Remove the plastic cap “a” and insert the part “c” on the flexible tape into the mouthpiece. The air starts to escape out of the child car seat. Leave the cap in this position during the whole time of the child car seat deflation. At the same time roll the child car seat from the farthest end towards the filling valve for the most air to escape from the child car seat. -
Page 9: Installation Instructions And Placement Of The Gobooster Child Car Seat In A Vehicle
Place the inflated child car seat on the left or right seat of a vehicle. On the child car seat, check the position of the upper belt holder whether it is located on the correct side according to the left or right position of the child car seat in the vehicle. -
Page 10: Using Of The Adjusted Gobooster Child Car Seat And Seating Of The Child
Seat the child onto the child car seat • Release the buckle “trident” of the holder • Fasten the child and the child car seat with adult three-point safety belt • Fasten the buckle “trident” so that the safety belt strap coming over the child chest •... -
Page 11: Risk Factors
Please pay close attention to your safety belts. Some three-point safety belts are not safe to the use with the child car seat, mainly in older cars even if they look very much like seat belts that are safe to use. If you are not sure consult the service instructions for your car. -
Page 12: Airbags
Only one child is to be transported in one child car seat; Re-adjust the child car seat provided the child has changed its parameters – height, weight or if another child is transported in the child car seat than for whom the basic adjustment has been carried out;... -
Page 13: Unsuitableness Of Child Car Use
When handling the child car seat avoid the contact with sharp objects and negative effect by forbidden substances; Provided the child is not able to keep up in the child car seat in a safe position, do not use the GOBOOSTER child car seat and choose another child restraint system for transport of the child. -
Page 14: Storage
- Fold the longer size of the child car seat half-and-half; - Fold the folded child car seat into three parts so that the filling valve remains on the upper side; - Place the folded child car seat into the textile casing. -
Page 15: Repairs
Manufacturer´s information Clean the textile surface of the GOBOOSTER child car seat by means of a little sponge with lukewarm water with addition of soap or detergent – shampoo. Warning Do not use any solvents for cleaning. Any liquid, small objects and other impurities must not get into the valves. -
Page 16: The Guarantee And After Guarantee Service
Czech Republic Disposal of the GOBOOSTER child car seat and transport packaging - Dispose of the child car seat in a standard way like any other municipal waste at municipal waste disposal site. - Recycle the textile casing or dispose of at municipal waste disposal site. - Page 17 • the product complies with Regulation ECE No. 44 amendments series 04 • the manufacturer has implemented the quality management system, • the quality control of the GOBOOSTER child car seat has been carried out according to the Regulation ECE UN No. 44 amendments series 04 Note: The word “universal”...
- Page 18 25.3 Visual fitting instructions – information about the handling procedure with the GOBOOSTER child car seat and fastening belts in the vehicle.
-
Page 19: Guarantee Certificate
Damage caused as consequence of insufficient care. Type of product THE INFLATABLE CHILD RESTRAINT SYSTEM - the GOBOOSTER child car seat Date of sale Shop stamp, signature In case of any problems contact the dealer or the manufacturer: GUMOTEX, a.
Need help?
Do you have a question about the child car seat and is the answer not in the manual?
Questions and answers