Maintenance And Servicing Instructions; Troubleshooting; Technical Data - Salton SGS2 Instructions And Warranty

MAINTENANCE AND SERVICING INSTRUCTIONS

There is very little maintenance required on this appliance. Important points to
remember are:

Always check that the regulator seal is undamaged when changing the gas
cylinder.

Always check that the hose is in good condition before using, and that it is
securely clamped on to the appliance and the regulator.

It is recommended that the hose be replaced every two years whether it has been
used or not. When replacing the hose, ensure that the replacement hose is
suitable for LPG. Hoses should only be bought from certified gas dealers.
Remember, when replacing the hose, to replace the hose clamps at the same
time.

With the exception of the hose and the regulator, there are no user fitted parts
available for this cooker. Should the cooker not be functioning properly, an
authorised service agent must check it, and if replacement parts are required,
they will ensure that the correct parts are supplied and fitted correctly.

It is recommended to have your cooker checked at the beginning of every
season.
CLEANING

Wipe the exterior of the cooker with a soft cloth moistened with a mild detergent.

The pot supports may be washed in water with a mild detergent.

Only clean the cooker when it is cold and not in use.

When not in use, store the cooker by covering and placing it in a cool, dry and
dust free area.

Never immerse the unit in water or let water come into contact with the burners.
TROUBLE SHOOTING
Problem
Cooker will not light.
Gas smell present
Burner has erratic
flames
If you need to return the appliance, ensure that:

The unit is packed carefully back into its original packaging.

Proof of purchase is attached.

TECHNICAL DATA

Brand Model
Salton SGS02
Operating Pressure
2.8 kPa
Possible Cause and Solution

Cylinder is empty. Replace with filled cylinder.

Electronic ignitor is wet. Clean and dry the ignitor.

Cylinder valve is closed. Check the cylinder valve.

Burner is not lit. Re-ignite it.

There is a gas leak. Check for leaks as per the procedure
described previously.

The gas supply hose is damaged. Inspect and replace it if
necessary.

Cylinder is nearly empty. Replace with a filled cylinder.

Air dampers have not been adjusted correctly. Adjust the
air dampers as per the description in "Instructions for Use".

Burner components have not been assembled correctly.
Check and rectify as required.
Rated Gas Consumption
Small Burner (g/hr)
Large Burner (g/hr)
Combined (g/hr)
5
Rated Power
210 Small Burner (W)
250 Large Burner (W)
460 Combined (W)
2900
3450
6350