Table of Contents
Advertisement
Malfunction search diagram atmospheric gas-fired heating appliance with electronic ignition: Starting up cycle
Start
1.01 Does receiver beep?
no
1.02 Receiver
-
Batteries missing or empty.
Replace by 4x AA.
When replacing batteries short
beep: no beep: receiver defective.
Replace by new one.
-
Replace rechargeables by alkaline
batteries.
-
Communication code between
remote and receiver has to be
(re)set:
Press reset button on receiver until
brief beep followed by long beep.
Release reset button and press
'flame low' button on remote
within 20 seconds
-
Then 2 short beeps and brief noise
of servomotor to confirm that
communication code was set
succesfully.
Remote set
-
Battery 9V empty (see indication
on display)
Several
-
After switching off/going out the
remote set is locked for 120 sec.
(older versions 60 sec).
Wait 2 minutes before reigniting.
UK
1.03 One long 5 second beep,
yes
(possibly preceded by 7 short
beeps)
yes
1.04 Check
All appliances
-
8 wire cable between receiver
and gas control not connected,
poor contact, or one wire loose
in connector. (check by pulling
wire by wire).
-
Wiring of thermocouple circuit
interrupted, or poor contact.
Check thermocouple,
thermocouple interrupter and
wiring.
Sie box 2.05.
-
Microswitch on gascontrol
defective.
Appliances with 2nd thermocouple
only
-
2nd thermocouple not cooled
down sufficiently. Wait till
cooled down (voltage < 1.2mV,
measure between black
extension wire and earth).
-
Wiring of 2nd couple
interrupted. Check wiring, see
box 2.13.
-
Else: receiver damaged, replace.
1.05
Short beeps, 1sec after another,
followed by clicking noise of gas
no
valve opening, possibly followed
by ticking sounds of ignition
attempts.
no
1.06 3 swift short beeps
(within 1 sec time)
yes
1.07 Replace batteries
IN S TA L L A TI O N M A N U A L
yes
1.08 Remote control system
is OK
Continue with "Fires with
electronic ignition, fault
finding ignition and burning"
Advertisement
Table of Contents
