Advertisement
Assembly Instructions
Fig 3
b)
STEP 3
Starting from the upper horizontal frameworks, attach the Corner Bracket and Extension Bracket to
horizontal Framework Bar with the Torx Screws, as shown in a Fig 3. Again as in case of Corner Bracket
(Fig 2e), it is recommendable to insert the Fabric Holder temporarily inside the slot marked by a) to ensure it
fitting there also after tightening the Torx Screws of Extension Bracket. Make also sure the Corner Bracket
becomes in contact with the recess edge of Framework Bar, as marked by b). Then lift the bar hanging to
the Wall Sockets of Wall Plates.
Fig 4
STEP 4
Similarly now built the other side of upper horizontal framework bar, but now first string the Wall Mount Side
to the Wall Socket in side, after which connect the other end to the Extension Bracket, exactly as presented in
Step 3.
Finally do the same procedure to the lower horizontal Framework Bars, which are full mirror images for the
upper bars.
c)
a)
c)
Fig 5
wall
b)
STEP 5
Now complete the framework by adding the vertical side and center bars (Fig 5). The side bars are attached to
corner brackets with Torx Screws. It is important that the side bars are oriented so that the hole on a recess of
both bars are located on the side of wall (Fig 5b). Again make sure the each Corner Bracket becomes in
contact with the recess edge of Framework Bar, similarly as with horizontal bars, marked by b) in Fig 3.
The vertical center bars are attached to horizontal bars by two Cap Screws m8 x 50. The bars are oriented so
that the recess is formed to the opposite side of wall as shown in Fig 5c. Tighten the all screws securely by
using the L-wrench, 6 mm.
Still screw the four Set Screws, m6 x 8 to the screw holes of both upper and lower Wall Mounts at location
shown in Fig 3c to an extent that prevents the bars falling from the Wall Socket.
Video Screen
Cinoscreen F-100 / F-AT100
wall
recess
c)
Advertisement
