jWIN JC-CD260 Instruction Manual

Car cd 12/45sec / mp3 120sec asp player receiver (am/fm) detachable front panel

Advertisement

JC-CD260

Instruction Manual

Mp3 CD/C D / C D - R / C D - R W P L A Y E R
DISP
RPT
RDM
SCAN
ALL
PTY
MUSIC
MUTE
LOUD
MONO
AF
60 WATT/DIGITAL TUNING SYSTEM
SCN
A/PS
2
1
INT
CAR CD 12/45SEC / Mp3 120SEC ASP PLAYER
RECEIVER (AM/FM)
DETACHABLE FRONT PANEL
R
DIR
SONG
CLASSIC
CLK
BND
MUT
JAZZ
EON
ST
LOC
LUD
4
5
6
3
RDM
D-DN
D-UP
MODE
RPT

FUNCTION OF CONTROLS

19
1
7
17
M P 3 C D / C D / C D - R / C D - R W P L A Y E R
DISP
RPT
3
MUSIC
MUTE
SCN
A/PS
1
20
15
2
11
CONTROL
FUNCTIONS
1.POWER ON/OFF
Press any key to power up the unit.
Press this key for more than 1 second to turn off unit.
2,3. SEL (control mode select)/MENU KEY
Push to select the desired mode,VOL(volume),BAS(bass),TRE(treble)
BAL(balance),or FAD(fader).
This button normally functions as the volume control.Adjust the level
rotate(3) after selecting the desired control mode.Otherwise the mode
will go back to the volume control mode.
Control Mode
Turn clockwise:
Volume control
For less volume
Bass control
For less bass
Treble control
For less treble
Balance control
To decrease the right speaker volume
Fader control
To decrease the front speaker volume
MENU KEY
Hold the SEL key to choose the menu.
1) menu1:
Press and hold longer than one second to activate the DSP feature.
DSP mode sound effect as shown in sequence below.User setting value of bass/treble in normal
mode is always memorized.In rock/classic/pops mode,bass/treble mode is skipped and level is
not changeable
FLAT----CLASSICS----POP M----ROCK M----DSP OFF.
Bass and Treble gain of each mode is as shown in below table.
Initial value of bass/treble in NORMAL mode is 0 dB.
6
18
5
RDM
SCAN
ALL
DIR
SONG
CLASSIC
BND
JAZZ
LOUD
MONO
AF
PTY
EON
ST
60 WATT/DIGITAL TUNING SYSTEM
2
3
4
5
6
MODE
INT
RPT
RDM
D-DN
D-UP
21
22
23
12
13
10
Turn counter clockwise:
For more volume
For more bass
For more treble
To increase the left speaker volume
To increase the rear speaker volume
Rotate the SEL knob
-- 1 --
14 16
9
MUT
CLK
LOC
LUD
4
8
to select

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JC-CD260 and is the answer not in the manual?

Questions and answers

Summary of Contents for jWIN JC-CD260

  • Page 1: Function Of Controls

    JC-CD260 Instruction Manual Mp3 CD/C D / C D - R / C D - R W P L A Y E R DISP DISP SCAN SCAN SONG SONG CLASSIC CLASSIC JAZZ JAZZ MUSIC MUSIC MUTE MUTE LOUD LOUD MONO...
  • Page 2 LCD DISPLAY BASS (F=100HZ) NORMAL X dB DSP OFF FLAT M 0 dB FLAT ROCK M 6 dB ROCK CLASSIC CLASSIC M 2 dB POP M -4 dB 2) menu2:BEEP ON--BEEP OFF The situation of beep sound is selected.The 2 mode is selected as also vol up or vol dn key.
  • Page 3: Cd Control Location Of Parts

    CD CONTROL LOCATION OF PARTS M P 3 C D / C D / C D - R / C D - R W P L A Y E R DISP DISP SCAN SCAN SONG SONG CLASSIC CLASSIC JAZZ JAZZ MUSIC MUSIC MUTE...
  • Page 4: Speaker Wiring

    REMOVING THE FRONT PANEL Front Panel Release Button INSTALLING THE FRONT PANEL INSTALLATION NOTE: Choose the mounting location where the unit will not interfere with normal driving function. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected properly and the unit and the system work properly.
  • Page 5: Using The Reset Button

    USING THE RESET BUTTON Press button with a thin, pointed object if unit is malfonctioning. Though not a normal occurrence, the microprocessor which controls the operation of this unit can be affected by electrostatic noise. This generally is indicated by such symptoms as no power being supplied when you switch the unit on, failure of buttons and controls, or an abnormal display.

Table of Contents