Connecting Your Cd Player; Operating Your Cd Player - Vecteur CDi4 Manual Manual

Connecting your CD player

1. Connection to the power
·
Check that the voltage switch is on the position corresponding to your local network ,
·
Connect the AC power cord
Connection to the amplifier
2.
Depending on the caracteristics of your amplifier, you may use:
·
Analog outputs:
"audio Input" jack supplies of the amplifier by using the pair of standard signal cables.
Please make sure the correct connection for the right and left channel (red and white
connectors)
·
Digital outputs :
Using a standard 75 Ohm coaxial digital cable, connect the units coaxial digital
o
output to the digital coaxial input of outside D/A decoder
Connect the outside D/A decoder output analog to the analog input of your
amplifier.
This CD player has a digital optical fibber output that can be connected to the
o
optical fibber input of your amplifier, MD recorder...
Turn your CD player on
3.
Push the on/off button on the front panel.
The LCD display is on.

Operating your CD player

Play
1. Press the Open/Stop button on the front panel or the "Open/Close" button on the remote
control and the disc tray slides out.
2. Put the CD on the drawer, label side up.
3. Press the Open/Stop button on the front panel or the "Open/Close" button on the remote
control and the disc drawer closes.
4. Then, the display indicates the number of tracks on the disc and its total time.
5. Press « play » on the front panel or on the remote control to start playing the disc. If the
drawer is still open , it will automatically close
Pause
During the playback, press the « pause » button on the front panel or on the remote control to stop
momentarily the disc playing.
Press the same « pause » button to restart the playback.
When the CD player is on « pause » mode, the disc still rotates. So don't leave the unit on "pause"
for a long time, as it could shorten the life time of the motor.
Stop
During playback or on « pause » mode, press the "open/stop" button on the front panel or the
"stop" button on the remoter control to stop the disc and reset the CD player.
CDI4.MUen.00
Connect
the "Analog Output" jack supplies of the CD player and the
Vecteur CDi4 Owner's Manual Page: 6/8