JVC KV-V8 Service Manual page 15

2.2.6 Loading motor
(1) Remove the belt from the worm gear assembly.
(2) Take out the 2 screws (A) and then remove the loading
motor.
Note:
• When installing the loading motor, hold it so that the
label faces upward. Also take care with the wire colors.
Red line
(to pin 1 of connector
for the loading motor)
Loading motor
Worm gear assembly
Fig.2-2-6a
2.2.7 Lever assembly, sub deck assembly, capstan motor
(1) First remove the belt from the rear side (capstans) of the
mechanism assembly.
(2) Take out the slit washer, then remove the lever assem-
bly.
(3) Take out the 3 screws (A), then remove the capstan mo-
tor and sub deck assembly together.
(4) Take out the 3 screws (B), then remove the capstan mo-
tor from the sub deck assembly.
Note:
• Before removing the capstan brake assembly, it is re-
quired to first remove the worm gear assembly and the
control cam.
Back side
Mechanism assembly
Fig.2-2-7a
(A)
Sub deck
Assembly
Fig.2-2-7b
Label (Top view)
(A)
(A)
Belt
Belt
Slit washer
Lever assembly
(B)
Capstan motor
Fig.2-2-7c
2.2.8 Control bracket
(1) Take out the screw (A) and screw (B).
(2) Remove the control bracket.
(A)
Fig.2-2-8a
2.2.9 Reel disk assembly (take up)
(1) Take out the slit washer.
(2) Remove the reel disk assembly (take up).
Reel disk assembly (take up)
Fig.2-2-9a
(B)
Sub deck assembly
(B)
Control bracket
Slit washer
2-5