Summary of Contents for GENESIS MOVE LED-MS20 R
-
Page 1: Table Of Contents
GENESIS MOVE TABLE OF CONTENTS LED-MS20 R 1. Safety Instruction 2. Technical Specification 3. How To Set The Unit 4. How To Control The Unit 5. Troubleshooting 6. Fixture Cleaning User Guide Professional Entertainment Technology... -
Page 2: Safety Instruction
1. Safety Instruction The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged. Caution Please read carefully the instruction, which includes important information There are no user serviceable parts inside the unit. Do not open the housing or attempt about the installation, usage and maintenance. -
Page 3: How To Set The Unit
3. How To Set The Unit Show Mode 3.1 Main Function Press the MENU button up to when the is showing on the display. Pressing ENTER To select any of the given functions, press the MENU button up to when the required one is button and the display will blink. - Page 4 ENTER button and the display will blink. Use DOWN and UP button to select the Display inversion mode for the fixture fixing under ceiling. (yes blackout) or (no blackout) mode. Once the mode has been selected, press the Focus Adjust ENTER button to setup or automatically return to the main functions without any change after 8 seconds.
-
Page 5: How To Control The Unit
3.2 Home Position Adjust and select (normal) or (2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led lights will constantly on. 2-light show (slave mode), means the unit works normally and means 2-light show. -
Page 6: Troubleshooting
4.4 DMX 512 Configuration If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit. -
Page 7: Fixture Cleaning
4. Try to use another DMX controller. 5. Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to DMX interface circuit. C. Some units don’t respond to the easy controller 1.