Extron electronics TeamWork 400 Kits Installation Manual

TeamWork Kits • Installation Guide
™
TeamWork 400 and TeamWork 600 Kits
The TeamWork 400 and TeamWork 600 kits consist of an HDMI switcher, system controller, Cable Cubby
cables packaged together as a complete system that, in most cases, requires no configuration.
Extron
SW4 HDMI
Switcher
Extron "Show Me" Cables
The diagram above shows a typical TeamWork 400 application. The input devices (laptops and a tablet) connect
to the switcher, using "Show Me" cables. The "Show Me" cables allow the user to select the active input on the
switcher.
A control cable connects the RS-232 ports on the switcher and the system controller.
The system controller powers the display on and off. The system controller has been configured so that when a
video signal is detected on any of the switcher inputs, the display is powered on. A 30 second timer is started when
no signal is detected on any of the switcher inputs. If an active source is detected before the timer expires, the
display remains on and the timer is reset. If 30 seconds pass without an active signal, the system controller powers
off the display.
The TeamWork kits work, as described, without further software configuration. If you need to change the behavior
or operation of the system, you must configure the system controller (see the IPL T PC1/IPL T PC1i User Guide at
www.extron.com).
Contact Closure
& Tally
T E
M O
R E
O U T
L LY T O
A U
TA
U T -2 32
T P + V R S
4
O U
3 C T
2
1 N TA
C O R x
T x
G
4
3
Extron
2
1
4
HDMI Pro Cable
T S
P U
IN
3
HDMI Video
2
I
D M 1
4 H
S W
R
W E
P O
1 2 V A X
A M
0 .3
Extron
Cable Cubby 800
Cable Access Enclosure
US
® T
17T
TED DE O
LIS DIO /VI TU S
AU RA
M APA
CO
L A N
V
+5
RX
TX
IR
T
IN PU
z
/6 0H
50
G
0V S
0- 12
10 IN
A X
A M
12
U T
U TP
R O
W E
P O
A X
Extron A M
12
IPL T PC1
Flat Panel
System Controller
AC Cord
RS-232
Control Cable
Flat Panel
Display w/ Integrated
Speakers
, and
®
1