Replacing The Fan [15 Min]; Replacing The Upper Protection Glass [15 Min]; Replacing The Lower Protection Glass [15 Min]; Replacing The Housing Top [30 Min] - Polaroid Polaview 3000 Repair Manual

BOARD LEVEL POLAVIEW 3000
SERVICE MANUAL

Replacing the fan [15 min]

The fan (7) is mounted on the housing bottom by four nuts. Disconnect the fan cable from the controller board (15)
and remove the four nuts.
Replace with a new fan.

Replacing the upper protection glass [15 min]

To replace the upper protection glass (2), follow the above procedure on replacing the LCD module. If the glass is
broken, observe the surface of the LCD module for scratches that may affect the display quality and replace the LCD
module if necessary. Wrap broken glass thoroughly.
Replace with a new glass, reversing the above procedure.

Replacing the lower protection glass [15 min]

This glass (9) is removed from the outside, without opening the display unit, and may be performed by the user. The
glass is held in place by springs. Use two fingers to slide the glass out and replace with a new glass. Refer to the
instructions in the User Guide.
Check that the new glass is correctly ground on the edges to avoid cutting wounds.

Replacing the housing top [30 min]

Remove the LCD module (4) and upper glass (2) as described previously under LCD module replacement.
Also remove the keyboard (11) and cable (12).
Replace with a new housing top, reversing the above procedure.

Replacing the housing bottom [30 min]

Remove the controller board (15) and fan (7) as described previously.
Replace with a new bottom part.

Replacing the speaker [15 min]

Unplug the speaker cable (13) from the controller board (15). Unscrew the four nuts holding the speaker (13)
Replace with a new speaker.
7