JVC HR-S7600U Instructions Manual page 59

INSERT
1
4
7
C.RESET
1
HR-S7600U-EN45-64
JOG
SHATTLE
2 3
2
5 6
8 9
0
4
59
ENGAGE INSERT EDITING
6
Press INSERT.
Your VCR enters the Insert-Pause mode. (
light up on the front display panel.)
The TV screen changes from the still picture to the
input source you are going to record.
START EDITING
7
Load the source cassette and play back the segment
that is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your VCR; Insert Editing begins
at this point.
and are displayed on the front display panel.
END INSERT EDITING
8
At counter "0:00:00", Insert Editing will stop automati-
cally and both tapes will continue running in the Play
mode. If you wish to stop Insert Editing before the
specified edit-out point, press C.RESET.
FOR AV INSERT EDITING
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
In step 6 above, after you press INSERT, press A.DUB also.
( and blink and lights up on the display panel.)
NOTES:
Insert editing is not possible with cassettes whose safety tab
has been removed.
In insert editing, the recording speed (SP/EP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
A small portion of the recording which precedes an insert edit
may become erased.
Insert Editing is also possible using the rear connectors.
When using these connectors, be sure to select the correct
REAR AUX INPUT ("VIDEO" or "S-VIDEO"). To select the
correct REAR AUX INPUT, follow steps 4 – 6 from the "Edit
From A Camcorder" section,
99.4.28, 2:05 PM
59
EN
, and
pg 56.