Table of Contents
Advertisement
VCR
1
NUMBER "1"
4
7
1
STOP
TV PROG+/–
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL
CODE
2
While holding down VCR on the remote control, press
the NUMBER key "2" and then press STOP.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press
on the remote control. The recorder will now
only respond to B code signals.
NOTES:
Some TV sets may malfunction in response to the B code. If
this happens, switch back to the A code.
To set the recorder back to respond to A code signals, repeat
the same procedure as shown above except pressing
NUMBER key "1" instead of "2" in step 2.
– –:– –
2
3
2
NUMBER
5
6
8
9
0
4
Satellite Receiver Multi-
Brand Remote Control
Your remote control can operate the basic functions of your
satellite receiver set. In addition to JVC satellite receivers, other
manufacturer's satellite receivers can also be controlled.
Before you start . . .
Turn on the satellite receiver using its remote control.
SET SATELLITE RECEIVER
BRAND CODE
1
Refer to the chart below. While holding down SAT on
the recorder's remote control, enter your satellite
receiver's brand code using the NUMBER keys, then
press STOP.
Check if the satellite receiver's power goes off as it
should. If it does, try other operations (
Once you have set the remote control to operate the
satellite receiver, you don't have to repeat this step
until you replace your remote control's battteries.
Some satellite receiver brands have more than one
code. If the satellite receiver does not function with
one code, try entering another.
OPERATE SATELLITE
RECEIVER
2
First, press SAT to set the remote control to satellite
receiver mode, then press the corresponding button:
, TV PROG +/–, NUMBER keys.
For VIDEOWAY or some brands of satellite receiver,
you must press
NUMBER keys.
The NUMBER buttons may not function with some
satellite receivers.
IMPORTANT
Although the provided remote control unit is compatible with
JVC satellite receivers, as well as many other models, it may not
work with your satellite receiver, or in some instances, may
have limited function capability.
SATELLITE RECEIVER BRAND
JVC
AMSTRAD
GRUNDIG
HIRSCHMANN
SIEMENS
WISI
KATHREIN
PACE
PHILIPS
FINLUX
ITT
NOKIA
SALORA
RFT
SKYMASTER
MASPRO
BT
PANASONIC
JERROLD
VIDEOWAY
29
step 2).
after having pressed the
CODE
13, 14
01, 02, 03, 04
05, 06
05
05
05
05, 11, 12
06, 08
07
09
09
09
09
10
10
11
13
15
16
17
Hide quick links:
Advertisement
Table of Contents
