Advertisement
2.
INTRODUCTION & SPECIFICATION
Professional dual air nailer/stapler with lightweight aluminium body and rubber grip handle. Safety trigger device
to prevent accidental firing of nails and staples. Supplied in blow-moulded case with oil and starter pack of nails
and staples.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SA792
Capacity (staples): . . . . . . (Crown 5.7mm 18Ga) 10-40mm
Capacity (nails): . . . . . . . . . . . . . . . . . . . . (18Ga) 10-50mm
Operating Pressure: . . . . . . . . . . . . . . . . . . . . . . . 60-100psi
Air Inlet: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4" BSP
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5kg
fig 1
TRIGGER
DRIVER GUIDE
PLATE HEX BOLTS
TRIGGER
RELEASE
SLIDE
3.PREPARING GUN FOR USE
3.1.
Air Supply
3.1.1. Before connecting to an air supply ensure that the trigger release slide is not depressed (see fig.1).
3.1.2. You will require an air pressure between 60-100psi.
3.1.3. WARNING! Ensure the air supply is clean and does not exceed 100psi while operating the nail/staple gun.
Too high an air pressure and unclean air will shorten the product life due to excessive wear, and may be
dangerous causing damage and/or pe rsonal injury.
3.1.4. Drain the air tank daily. Water in the air line will damage the nail/staple gun and will invalidate your
warranty.
3.1.5. Clean air inlet filter weekly. Recommended hook-up is shown in fig 2.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
The minimum hose diameter should be 1/4" I.D. and fittings must have the same bore.
3.1.7. Keep hose away from heat, oil and sharp edges. Check hoses for
wear, and make certain that all connections are secure.
3.2.
Couplings
Vibration may cause failure if a quick change coupling is connected directly
to the air nail/staple gun. To overcome this, connect a leader hose to the nail/
staple gun. A quick change coupling may then be used to connect the leader
hose to the air line recoil hose. See fig 2 & 3.
fig 2
NAIL/STAPLE OUTLET
Original Language Version
AIR INLET
MAGAZINE CATCH
MAGAZINE INDICATOR
MAGAZINE
fig 3
SA792 Issue: 2 - 13/11/09
Advertisement
