Table of Contents
Advertisement
Quick Links
Talk-A-Phone Co.
Creating Communication Solutions
Installation & Operation Manual
Section
Getting Started
Hardware Installation
Programming the Base Station
Operation
FCC Information
Phone Line Specifications
Information to the User
Talk-A-Phone Co. Limited Warranty
All Specifications and other information are subject to change without notice.
For EB-200 Base Station
Talk-A-Phone Co.
7530 North Natchez Avenue
Phone: (773) 539-1100
e-mail: info@talkaphone.com
Niles, Illinois 60714-3804
Fax: (773) 539-1241
http://www.talkaphone.com
© 2009 Talk-A-Phone Co. All rights reserved.
Page
2
3
4
5
6
7
8
9
Rev. 7-27-09
Advertisement
Table of Contents
Summary of Contents for Talk-a-Phone EB-200
- Page 1 Talk-A-Phone Co. Limited Warranty Talk-A-Phone Co. Rev. 7-27-09 7530 North Natchez Avenue Niles, Illinois 60714-3804 Phone: (773) 539-1100 Fax: (773) 539-1241 e-mail: info@talkaphone.com http://www.talkaphone.com All Specifications and other information are subject to change without notice. © 2009 Talk-A-Phone Co. All rights reserved.
-
Page 2: Getting Started
Any significant noise on the telephone line will also interfere with the functioning of the EB-200. If you are planning on connecting the EB-200 to a digital phone line, be sure to read the Special Instructions for Using a Digital Phone Line. -
Page 3: Hardware Installation
Phone/Iwatsu PBX system, please call Talk-A-Phone’s Technical Support line at (773) 539-1100. 5. Once the rest of the installation is complete, test out the EB-200 to see if the LED's light when you receive a call. Figure 1. Connecting the Base Station to a digital phone handset Talk-A-Phone Co. -
Page 4: Programming The Base Station
III. Programming the Base Station If the EB-200 Base Station is attached to a serial port printer, you will want to program the Base Station to meet the specifications of the printer and with the other data that will automatically print out with each call. -
Page 5: Operation
Emergency Phone's ID code, see page 10 of the Emergency Phone Manual. In addition, the EB-200 will indicate which button was pushed on a 2-button Emergency Phone (button 1 is the top button, usually EMERGENCY), if an Auxiliary Input was used to activate the phone in lieu of pressing a button and if either of the Auxiliary Outputs were activated (displayed as AUX's 2 and 3). -
Page 6: Fcc Information
H. The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The Talk-A-Phone Co. U. S. A. Service Center is located at 7530 North Natchez Avenue, Niles, IL 60714-3804, telephone number (773) 539-1100, fax number (773) 539-1241. -
Page 7: Phone Line Specifications
AC impedance, as well as a DC resistance of 100 — 200 . B. MODE II and MODE III Operation Talk-A-Phone phones can be used with most PBX systems with non-standard dial tones, ring-backs, busy signals and hang-ups. Talk-A-Phone Co. Page 7 of 9... -
Page 8: Information To The User
FCC limits. D. Talk-A-Phone Factory Service Talk-A-Phone factory service is available to Talk-A-Phone users at a reasonable charge, plus transportation to and from our factory. When you send units to our factory, freight prepaid, our technicians will examine, service and promptly return the units to you, transportation collect. -
Page 9: Talk-A-Phone Co. Limited Warranty
Models ETP-PM, ETP-MT and ETP-MT/R is five (5) years, under the same terms and conditions. In the event this product is found by Talk-A-Phone to be defective within the warranty period, Talk-A-Phone's only obligation and your exclusive remedy shall be the repair and/or replacement of any defective parts, provided the equipment is returned to Talk-A-Phone Co., 7530 North Natchez Avenue, Niles,...