End Of Year Cleaning And Maintenance - ALASKA KAST CONSOLE III Owner's Manual

END OF YEAR CLEANING AND MAINTENANCE

1. Remove the exhaust pipe. Thoroughly clean and
place in a dry location during nonburning months.
Clean exhaust tubes in stove body of all debris.
2. Remove coal from stove and vacuum clean.
3. Thoroughly brush inside of stove body, free of all fly
ash and vacuum clean.
4. Remove the Half Moon Paddle from feed tray, (loosen
the two setscrews at bottom of paddle allowing feed arm
to drop down). Pull Paddle out from top of feed tray,
clean shaft, lubricate, and reinstall.
5. Locate grate inside stove, clean all holes.
6. Locate Air Motor Tray. Remove bolt from bottom of
tray, disconnect wiring, and remove air motor tray.
Thoroughly clean motor and plastic combustion
wheel. Vacuum under grate through hole where air
Quality Since 1977
STOVE COMPANY
THIS HEATER IS ONE FOR BURNING COAL. USE OF ANY OTHER SOLID FUEL EXCEPT FOR COAL IGNITION PURPOSES IS A VIOLATION OF FEDERAL LAW
CHIMNEY TYPE: MINIMUM 6 INCH DIAMETER APPROVED LOW HEAT RESIDENTIAL TYPE ALL FUEL. CHIMNEY CONNECTOR: 6 INCH DIAMETER 24 GAUGE
BLUE OR BLACK STEEL. INSTALL AT LEAST 4 INCHES FROM WALL AND 6 INCHES FROM CEILING. SPECIAL METHODS ARE REQUIRED WHEN PASSING
THROUGH A WALL OR CEILING. SEE INSTRUCTIONS AND BUILDING CODES. SEE DIAGRAM.
REAR VENT
4"
HOPPER
STOKER
18"
FRONT
INSTALL WITH MINIMUM CLEARANCE
TO WALL AS SHOWN (IN INCHES)
CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA
ALASKA COMPANY, INC.
BLOOMSBURG, PA 17815
MODEL: KAST CONSOLE, CHANNING, LIBERTY
U.S. ENVIRONMENTAL PROTECTION AGENCY
CONAM Inspection, Inc. Auburn, MA 01501 STL - 002
Tested 2/97 to ANSI/UL, CSA B366-1979 & ETLM 781
TOP VENT
10"
HOPPER
STOKER
18"
FRONT
motor tray was removed. Replace air motor tray,
wiring and bolt, Do Not Over Tighten Bolt!
7. Locate distribution blower. Thoroughly clean motor
and wheel of dust.
8. Inspect all gaskets and replace if necessary.
Note: All gaskets should be replace every three years.
9. Remove top of stove, Thoroughly clean inner top,
replace top.
10. Lightly spray WD-40 inside only of stove body.
11. Let stove stand for a few minutes. After stove has
ventilated adequately place a low watt lit bulb inside
stove body. This will aid in keeping dampness out
of stove.
NOTE: Important!! If grate has been removed make
sure gaskets are installed properly. See Page 2 Figure 1.
FUEL COAL
FLOOR PROTECTOR
MINIMUM SIZE
2"
8"
HOPPER
8"
STOKER
FRONT
USE APPROVED
FLOOR PROTECTOR
11
SERIAL NO.
CORNER INSTALLATION
6"
6"
8"
16"
13"
13"