Protex BG Series User Manual

DIAGRAM 1.0
DIAGRAM 2.0
2

WELCOME:

STEP 1 – OPENING THE SAFE:
1. Install the 4 AA batteries in the Power Override Box.
We recommend using high-quality batteries such as
Duracell or Energizer.
2. Plug the Power Override Jack to the Power Override
Hole.
3. Enter code. Factory default code is: 1-2-3-4
4. If the correct code is entered, the LCD Display will
show "OPEN". If a wrong code was entered the LCD
Display will show "E-CODE". Please re-enter the right
code.
5. The door will automatically open and the display will
show "OPENED" for 4 seconds.
NOTE: Remove the batteries from the Power Override Box and
install them in the battery box that is located in the back of
the safe door.

ENROLLING:

STEP 2 – CHANGING USER CODE:
1. Open the safe using the code.
2. Enter your new 4-Digit code and press the "LOCK" key.
STEP 3 – CHANGING MASTER CODE:
1. Open the safe using the code.
2. Enter your existing master code.
8-8-8-8-8-8
3. Press the "LOCK" key. The LCD Display will show "NEU".
4. Enter your new 6-Digit master code and press the "LOCK"
key. The LCD Display will show "AGAIN".
5. Enter your new 6-Digit master code again and press the
"LOCK" key. If procedure is successful LCD Display will
show "DONED", in case of a wrong code the LCD Display
will show "E-CODE". Please repeat steps 2 thru 5.
Factory default code is:
3