Advertisement
Quick Links
Advertisement
Summary of Contents for S&P IDEO
- Page 1 IDEO 325 Ecowatt Installation Manual...
- Page 2 Before manipulating this device, disconnect the electricity supply. During normal operation, never stop the ventilation system.
- Page 3 High-performance heat recovery dwelling unit Introduction This manual is destined for use with the IDEO 325 Ecowatt high performance heat recovery unit and its This manual is destined for use with the IDEO 325 Ecowatt high-performance heat recovery unit and its peripheral fittings (conduits, inlets, regulators…).
-
Page 4: Technical Information
Condensation may occur at the moment of exchange, with the introduction of fresh air. This is recovered in a container for condensate, which should be connected to a waste water drain. Thanks to its 100 % by-pass, the IDEO 325 Ecowatt enables you to cool your home in the summer. 100 % O 32 2.2 Description of the IDEO-HR... - Page 5 On having avoided the heat exchanger, the system of the by-pass 100 % of the IDEO 325 Ecowatt allows the introduction of the fresh air in the night without IDEO 325 Ecowatt allows the introduction of the fresh air in the night without being warmed by the warm air accumulated in the house during the day.
- Page 6 Dimensions Central unit: Weight: 51 Kg Remote controls: Programmable module Kitchen boost...
- Page 7 Placement Wall bracket On a vertical wall: It is recommended to locate IDEO in On the floor: heated house space. Otherwise it will be necessary to insulate the condensate drain pipework..
- Page 8 On the floor: An specific kit option Support NEVER FIT THE IDEO ON THE CEILING. It is recommended to locate IDEO in heated house space. Otherwise it will be necessary to insulate the condensate drain pipework. Tube cover: 4 x 4 x...
- Page 9 DIAGRAM OF STANDARD ASSEMBLY TYPE “DELIVERY” Outlet roof caps CT 150 Kitchen BDOP 125 BDOP 80 Toilets Toilets Air intake plenum (6+1 spigots) Air intake D150 Li i Living/sitting room / itti & Bedrooms PAF 150 Circular Air intake wall hoods 4 or 8 spigots distributor PAST Air intake roof D150...
- Page 10 DIAGRAM OF STANDARD ASSEMBLY TYPE “DISTRIBUTION” Outlet roof caps Outlet roof caps Living/ CT 150 sitting room BDOP 125 Kitchen BDOP 125 BDOP D80 RD80 Bedrooms Toilets Toilets BDOP D80 RD80 Air intake D150mm PAF 150 Circular Air intake D150mm PAST Air intake roof hoods D150mm...
- Page 11 When started, the central IDEO automatically adapts to the specific characteristics of each installation. If any component is missing or badly fitted, normal operation may be impaired.
- Page 12 The remote control module is in permanent communication with the IDEO central unit . Service life with normal use (consultation by the user 5 times a day on average) is estimated at about 3 years. Battery status can be viewed...
- Page 13 2.2.a . Description of the programming module: 15 13 1 – Adjustment mode using the clock 2 – Programming mode (Automatic 1 – Automatic 2 – Manual) d (A t ti 1 A t ti 2 M 3 – Day of the week 4 –...
- Page 14 1. To switch off the Ideo navigate with the keys 19 or 20 to see “ON”. Validate with the key 18, the "ON" will flash. With the keys 19 or 20 put on "Off" and validate with the key 18.
- Page 15 - Auto 2: Working week with three meals per day and the weekend, starting breakfast two hours later. Start Finish Start Finish Start Finish Monday 6:30 7:30 12:00 13:00 19:30 20:30 Tuesday 6:30 7:30 12:00 13:00 19:30 20:30 Wednesday 6:30 7:30 12:00 13:00...
- Page 16 • Viewing savings (14): The IDEO-HR enables you to view monthly savings from heat recovery in kilowatts at any time. Press key 17 continuously to view savings. • Remote control transmission/reception level (9): The remote control communicates permanently with the IDEO 325 Ecowatt. The transmission/reception level will enable you to know the quality of this signal.
-
Page 17: Intake Air
• Conditions under which the automatic defrosting icon is displayed (7): The IDEO has an automatic defrosting system offering good and economic performance. This system is automatically activated when the outside temperature from the fresh air intake is 1º C or lower.
Need help?
Do you have a question about the IDEO and is the answer not in the manual?
Questions and answers