Route The Cables Through The Arm Unit; Attach The Wall Mount To The Wall Plate - Epson PowerLite 420 Installation Manual

Installation.book Page 23 Monday, February 13, 2012 4:23 PM
3.

Route the cables through the arm unit

Route the projector's power cord, the USB cable supplied with the interactive module, and any
additional cables connecting to the projector through the arm unit.
Caution
Problems may occur if you use this product without routing the cables through the arm unit.
Route the included USB cable so that the type B connector emerges on the projector
q
side. Epson recommends labeling any duplicate cables (ex. USB cables for interactive
module and USB Display, etc.) so that additional connections can be more easily
identified.
4.

Attach the wall mount to the wall plate

1. Attach the hook on the arm plate to the bar on the wall plate.
2. Secure the arm plate temporarily using two M8 × 15 mm hexagon socket head cap bolts.
Caution
Take care not to trap the cables between the mount arm and wall plate.
Arm unit
USB cable for interactive module
Arm plate
Arm unit
23
Vertical adjustment
screw
Bar on wall plate
Wall plate
M8 × 15 mm
hexagon socket
head cap bolt (×2)