Page 2
PREMIER 2250 S&E SERIES SPECIFICATIONS For ¾”, 1” and 1¼” Water Mains Rating: ANSI/NSF 42 rated at 3,535,000 gallons for aesthetic chlorine removal. While testing was performed under laboratory conditions, actual performance may vary. Statement for claims: This system has been tested according to NSF/ANSI 42 for reduction of chlorine.
Page 3
LifeSource Water Systems are attached to the main water line going into the home. DO NOT CONNECT THE BACKWASH LINE TO AN AIR CONDITIONER DRAIN LINE.
Repeat this procedure of SLOWLY turning the control knob clockwise to RAPID After installing your new LifeSource Water System, it is extremely important that the RINSE (between 4 and 5 o’clock), stopping there and letting it run for two to three...
Page 5
Whole-House Water Systems MANUALLY BACKWASHING AUTOMATIC SYSTEM START-UP PROCEDURE / INITIAL BACKWASHING You will need to manually backwash your system at the time of initial installation and if: Continued from previous page • You are gone for an extended period of time. When you first begin the START-UP PROCEDURE and INITIAL BACKWASHING OF •...
Page 6
Older water heaters may de- that the timer is set at the correct time of scale with LifeSource water and should be drained after one month or so (as scale day. To determine if the timer has dislodges).
Page 7
That failure has not resulted from misuse, alteration, freezing, accident, fire or neglect. 4. Automatic Dishwashers: The automatic timer valve used by LifeSource Water Systems has a three year warranty on parts if installed as Spots on Glassware & Dishes, cut down on SOAP! Use only powdered dishwasher soap required by the manufacturer.
Need help?
Do you have a question about the Premier 2250-S and is the answer not in the manual?
Questions and answers