Power; Adjusting Volume; Changing Channels; Return. - JVC TV 20240 User Manual

9 G E T T I N G

POWER

Press the P button on the remote control or the TV/VCR combo front panel. The On Timer
OWER
lamp will glow red.
Make sure that the TV/CATV switch on the remote is set to TV. Switch to CATV only if you plan to
operate a cable box. If you switch to CATV you will not be able to operate the TV/VCR combo
functions with the remote, only the cable box functions!
To turn the power off, press the P
The On Timer lamp will glow green when the On/Off Timer is set to yes, even when the TV power
is off.

ADJUSTING VOLUME

1 Adjust the volume with the V
remote control. Press the V
raise the volume.
Press the M
2
UTING
previous volume level, simply press the M

CHANGING CHANNELS

1
10 key direct access.
Press the numbers on the remote's 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
2
C –/+ button.
HANNEL
Press the C –/+ button, to scan the channels in order.
HANNEL
After you operate the Auto Tuner Setup (page 12), all of the blank, or empty, channels will be re m o v e d
f rom scanning so that there is no noise or channel snow when you scan, only active channels.

Return.

3
Press the R button to return to the previous channel. First, select a channel
ETURN
(game #1). Then, select another channel (game #2) with the 10 key pad and push the R
to flip directly back and forth.
button again. The On Timer lamp will go out.
OWER
–/+ buttons on the TV/VCR combo front panel or on the
OLUME
– button to lower the volume. Press the V
OLUME
VOLUME 13
|||||||
button to instantly turn the volume off to zero. To restore the volume to the
S T A R T E D
-------------------
button again.
UTING
+ button to
OLUME
button
ETURN