HSS Hire 906 Operating Manual

To connect to mains set suction switch
and spray switch to "0". Insert power
plug.
An additional
plug-socket is
available for
connecting additional electrical
devices.

CLEANING

Set suction and spray switch to "I". Activate valve handle.
The cleaning agent solution is sprayed
and simultaneously sucked in.
Drive on the
surface to be
cleaned in
o v e r l a p p i n g
Valve handle
paths. Repeat
as necessary.
To clean dirty carpets spray cleaning solution and use
suction immediately. Using suction again shortens the
drying time. When the carpet is very dirty, firstly spray
cleaning solution. Wait around 10 - 15 minutes and use
suction to remove cleaning solution.
To obtain better result rinse the cleaned surface with clear
water. Remains of the cleaning agent and loosened dirt are
then rinsed out.
WARNING
IF YOU HAVE ANY DOUBTS, DO NOT CONTINUE,
CONTACT YOUR LOCAL HSS HIRE FOR ADVICE.

CLEANING TIPS

The more sensitive the carpet, use a smaller amount
of cleaning agent.
Carpets with jute backings can shrink and the colours
can bleed if the treatment is too wet.
High pile carpets should be brushed off first.
Cleaning with warm water (up to max. 50°C) is more
effective.
Spray very dirty areas beforehand.
Work from light to dark areas (from window to doors).
Work from cleaner areas to dirty ones.
Wait until cleaned surface is dry before walking on it.

EMPTYING DIRTY WATER TANK

When the dirty-water tank is full, the suction air is
interrupted by the mechanical floating switch.
To remove dirty water tank switch
off spray and suction switch.
Remove the cover and then
remove dirty-water tank and
empty it, or empty using a drain
Dirty water
hose.
If practicable, keep an eye on the
waste tank water level and empty
when about three quarters full.
Drain hose

EQUIPMENT CARE

Never push the equipment beyond its design limits. If it
will not do what you want with reasonable ease and speed,
assume you have the wrong equipment for the job. Contact
your local HSS Hire for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.

FINISHING OFF

Remove unused cleaning fluids
Hold suction hose in
from the housing with suction
fresh water tank
hose.
Remove the floor nozzle, hold
suction hose in a fresh-water
tank, turn "Suction" switch to
"ON" and wait until cleaning fluid is
removed and collected in dirty-
water tank.
Empty the dirty-water tank. Fill
fresh-water tank with 5l clean
water. Switch on spray switch.
Activate valve handle and rinse out unit for approx. 2
min. Switch off unit and pull the power plug.
Give the unit a final clean up ready for return, to your local
HSS Hire.
Cover
tank
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so. Training
is available at HSS Training Solutions
0845 766 7799
...any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: safety@hss.com
©HSS Hire Service Group Ltd 2010 No. 906/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
906/01 906/01
Operating & Safety Guide 906 Operating & Safety Guide 906
Professional
Professional
Carpet Cleaner
Carpet Cleaner
A powerful vacuum carpet
cleaner, designed for use on large
heavily soiled carpets.
Code 58342