Common Operations; Setting The Clock; Setting The Am Tuner Interval Spacing - JVC UX-L30UJ Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. When you plug the AC power cord into the wall
outlet, "0:00" starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press UP or DOWN to adjust the
hour, then press CLOCK/TIMER.
The minute digits start flashing on the display.
DOWN
UP
DOWN
CLOCK
/TIMER
3
Press UP or DOWN to adjust the minute,
then press CLOCK/TIMER.
To check the clock time during play
On the remote control ONLY:
Press DISPLAY.
• Each time you press the button, the source
indication and the clock time alternate on the display.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to "0:00" right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, set the clock again.
CLOCK
/TIMER
CLOCK/TIMER
UP
CLOCK/TIMER
DISPLAY
To adjust the clock again
1 Make sure
(timer) indicator is not lit on the display.
• If it is lit, press and hold CLOCK/TIMER until it goes
off.
2 Press CLOCK/TIMER repeatedly until the unit enters
the clock setting mode (the hour digit start flashing on
the display).
First time you press CLOCK/TIMER, the unit enters the
timer setting mode.
• See pages 20 and 21.
3 Repeat steps 2 and 3 of the procedure of "Setting the
Clock."
4 Press and hold CLOCK/TIMER again so that
(timer) indicator goes off from the display.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
When shipped, the built-in AM tuner is set to 9 kHz spacing.
You can change it to 9 kHz or 10 kHz spacing only while the
unit is on standby.
On the unit ONLY:
To select 10 kHz intervals, press
STANDBY/ON while
holding ¢.
To select 9 kHz intervals, press
STANDBY/ON while
holding 4.
When you change the setting
The preset stations are erased. You will need to preset the stations
again. (See page 12.)
– 9 –
DOWN UP
STANDBY / ON