Mechanical Instructions - Philips 29PT5445/85 Service Manual

EN 8 4. L03.1U AA

4. Mechanical Instructions

Index of this chapter:
4.1 Rear Cover Removal
4.2 Service Position Main Panel
4.3 Rear Cover Mounting
4.1 Rear Cover Removal
1. Remove all fixation screws of the rear cover.
2. Now pull the rear cover in backward direction to remove it.
4.2 Service Position Main Panel
1. Disconnect the strain relief of the AC power cord.
2. Remove the main panel, by pushing the two center clips
outward [1]. At the same time pull the panel away from the
CRT [2].
3. If necessary disconnect the degaussing coil by removing
the cable from (red) connector 0212.
4. Move the panel somewhat to the left and flip it 90 degrees
[3], with the components towards the CRT.
2
Figure 4-1 Service Position
Mechanical Instructions
1
A
3
B
CL 16532016_006.eps
4.3 Rear Cover Mounting
Before you mount the rear cover, perform the following checks:
1. Check whether the mains cord is mounted correctly in its
guiding brackets.
2. Re-place the strain relief of the AC power cord into the
cabinet.
3. Check whether all cables are replaced in their original
position
1
220501