Install Adsl Router - Getnet GA-121A Quick Installation Manual

3. Install ADSL Router

Step 1. Connect the ADSL Line
Use the supplied RJ-11 telephone cable, connect the router from the Line port to your
telephone socket with an ADSL micro filter plugged in.
Step 2. Connect the router to your LAN network
Connect the router to your PC, hub or switch by attached the Ethernet cable to the
LAN port of the router.
Step 3. Connect the Power Adapter to the Router
Connect the power adapter to the power jack on the rear panel of the router and
switch on the power.
Step 4. Check the ADSL LED light status
Please check the ADSL LED on the front panel. This light indicates the status of your
ADSL broadband through your telephone line. If the light is on solid, you can continue
the setup. However, if the light is flashing, there is no broadband line being detected.
Therefore, please call your Internet Service Provider (ISP) and inform them about the
flashing ADSL light.
Step 5. Firewall settings.
Please turn off all personal firewall before you continue the setup as they might block
the communication of your PC and the router.
Note：You must use the power adapter shipped along with the router, do NOT
use any other power adapter from other sources.